RC Receiver Controlled On/Off Lighting Switch PWM Receiver LED Control Spray Switch Remote Electronic AUX Channel Relay

I bought this to use on my Flysky GT5 for my lights. It does work, however not on channel 3. I did as instructed and set my endpoints up to 100(120 in the case of the GT5) as well as numerous other combinations between the trim, subtrim and endpoints. I could only get them to turn on or off buy adjusting the trim and never with use of the channel 3 button. However they do work on channels 5 and 6 the dials. So long as your ok with twisting your lights on instead of pushing a button this will work just fine. I feel this is more of an issue with how the FS-GT5 is set up and it programmability vs with this product. If any one has had success with getting this to work on the FS-GT5 on channel 3 I'd like to know what your settings on the controller are at.

As reviewer Moore indicated, if your lights stay on full time, you must remove the shrink wrap from the switch and simply de-solder the black leads from the JST connectors and put them into the other's original location. Put shrink wrap back on then all is well. The problem is that the "in" connector had a female JST connector on it to go to the lights and the male went to the power source and the connectors needed to be reversed. Contacted vendor originally for assistance and they were very helpful even sending a new switch to see if it solved the problem.

Product needs Clear Instructions. And better quality control. Input and output where reversed on my Switch.I recieved my Switch and installed on my 3rd Channel for Tactics Reciver. Lights stayed on no matter what. I removed the Insulation to find Constant Continuity between battery Negitive and output to lights through the Male 2pin plug. But no continuity between battery negitive and Input 2pin female plug to Receiver. Looks like wire connectors where switched. As I could not remove the Male 2pin plug from wires. I simply removed the 2 black wires from Input and output and swapped and re soldered back on. Some New Insulation. And unit works great.

Gave 4 stars instead of 5 for not having protection from polarity reversal. My own fault for frying two of them while experimenting lol but it worked before that so I ordered more. Used it fine with with Spektrum AR8000 & AR400. Was able to create camera trigger by just closing the loop on the device side.

As others have said, I switched the negative wires on the device and it works perfectly. It's my only flaw with the device.

The documentation does not state that you need more than 5 volts across the circuit you are controlling for it to work. I was trying to control a 5v led lighting circuit and it would not work. Because it is not well documented I wasted my money. Very disappointed. I gave it a three since they failed to note that, not due to any quality issue.

We used this relay to provide remote control of electronics on an RC airplane. Relay connects to the receiver and then we connected the other cables to a 9-V battery and some electronics. Pilot flips switch on the transmitter to turn it on/off.

Works as expected...if the switch does not work check your polarity...I had the power out wires reversed and could not figure out why it would not work then I switched wires and binge works perfectly