LINKITOM Submersible LED Trailer Light Kit, Super Bright Brake Stop Turn Tail License Lights for Camper Truck RV Boat Snowmobile Under 80" Inch

I had to alter the holes that the bolts were originally in, not a good fit when replacing lights. I should have just sent them back.

These are a lot bigger than I was expecting, but they look great. I used them on my 5'x10' Tractor Supply trailer that I recently painted and rewired. I had to drill new mounting holes because the spacing isn't very forgiving, but after that, they mounted securely. They come with everything needed to wire them up. Instructions are fairly clear. I'm happy with them, and the price was reasonable.

The kit is supposed to be water proof however, when you get it, look at the back of the lights. The slots for the bolts are wide open along with the hole where the wires come out aren't sealed well. THEY WILL LEAK! but I used some clear silicone and filled the holes. Slide the bolts into place then silicone some more. Tested them in a bucket to make sure they would not leak before installing them. I installed them and used most of my own supplies. Water proof shrink tube style but connectors and a dedicated ground rather than relying on the trailer frame. The directions don't tell you what to do with the wires on the right rear light green, brown and red. Or the side marker light wires yellow AND black. However if you do enough research you will find this information on the Amazon page above the question and answer area.How to install:This light has 2 types of wiring:1. If the color of the wire on light is red, brown and green, then brown wire is the ground and green wire is the running light, red wire is brake/turn lightPlease attach the brown wire to towing Trailer 's frameconnect the green wire to brown wire on harnessconnect the red wire to green wire on harness2. If the color of the wire on light is white, brown and green/yellow, then white wire is the ground and brown wire is the running light, green/yellow wire is brake/turn lightPlease attach the white wire to towing Trailer 's frameconnect the brown wire to brown wire on harnessconnect the green/yellow wire to green/yellow wire on harnessOn the yellow side marker lights:Black/gray wire is the ground(Attach the BLACK/GRAY GROUND wire to the towing Trailer 's frame)Yellow wire is the side marker lightAfter doing all that, the lights work pretty good and look ok too. They are very bright. Hope they last a while and hope my silicone holds for a while.

The LED lights are bright but not C DOT approved. The reflector tape faded fast!!! Tape is junk for sticking, even with additional spray adhesive!! Had to purchase better actual C DOT reflective tape and that doesn't fade and stayed stuck for the same duration. The wires are ok, but too thin stranded copper. The Ground wire broke because it is too thin (the smallest crimp on is too big) so I have to buy more wire as the supplied wire really isn't that good. I will splice the ground with a better thicker tinned wire and reattach it to a good metal ground. Length of wire is sufficient could be better. All in all, this worked with a little DIY modification. Wires could be better, and the reflective tape is a complete waste of time and money.Jan 2022 One turn light quit working. At first hooks up ok, then must be a loose connection. I soldered my connections, so the issue must be the sealed light.

Had an issue with taillight not working. I thought maybe bad ground,maybe wires were crossed inside light fixtures. I contacted seller. They made it right by sending replacements.

very easy to install, everything needed is there. I did all new lighting and all new wiring, plugged in to truck and everything worked on my first try

Purchased for 1990 model boat trailer.Just got them mounted. Lights are working. Have not taken boat to the lake yet to test water reesistance.

Lights work great on my boat trailer