Jandy Genuine Parts Water Pressure Switch only kit, R0013200

Used this to replace a 17 year old original pressure switch. I used 2 cc of SAE 30 oil, wired it up and used Teflon tape on the fitting. While I was in the heater I took time to remove all the spade plug connectors and cleaned the terminals of corrosion using a flat file and 300 grit sandpaper. The terminals get oxidized over time and increase resistance at the connections. Take pics of the wires if unsure where to reconnect before you do that though. Overall job took an hour to do which included backwashing my filter element. I also checked the high limit switches to make sure they were ok. A multimeter comes in handy. This saved me hundreds!! Was facing $3500 installed for a newer JXI model.

I chose this rating because this little item allowed me to have perfect operation of my Teledyne Laars 15 year old propane pool heater that the local gas line expert could not diagnose. After installation of a new propane gas valve for the heater, it still did not function, and I was told the valve was the problem and should be sent back. After internet searching and speaking with a Zodiac representative (new owners of Jandy), a techie friend and I found the old pressure switch to be defective. I purchased this from Amazon, installed it according to printed and Zodiac verbal instructions -- amazing, heater turned right on and has operated without incident since.As others have noted, the item actually sold and delivered is a newer version and not the white ceramic switch pictured here. Apparently the newer Jandy propane pool heaters do not need the oil in the line this switch is to be attached to. Zodiac technicians confirmed my heater needed the oil in the line, and to make sure it was a non-detergent product.

PRODUCT IS NOT THE SAME AS IN PICTURE

Easy to install, and by replacing this myself, I saved a ton of $$$ from having to call a heater guy. A little pricey, in my opinion, for what it is, but worked perfectly. I have a Jandy "Lite 2" pool heater, fyi.

These seem to fail every year or two

The water pressure light of my pool heater kept blinking and the heater would not ignite. I bridged the pressure switch by a regular switch just to see if ti would resolve the issue and low and behold it did. Time for a replacement. I found this switch at Amazon and even though it looks quite different from the original, the reviews assured me that it wouldn't be a problem. I ordered and installed it in 10 mins and it works perfectly. I think it's even better than the original since you can adjust the PSI from 2 through 10. I use 2.

The brass fitting did not arrive in the package. Can't install without it. Now I have figure out where to buy this.

Was having a problem with my pool heater and this switch was the culptret, the old one was leaking and no longer fuctional. Was easy to install and fixed my pool heater in a matter of minutes. Anyone can replace one, and plenty how to instructions on line if you really need them.