3D Touch Auto-Levelling Sensor, Auto Bed Leveling Sensor, Touch Smart Sensor For 3D Printers, Improve Printing Precision

Tested this just wired to a new SKR 1.4 board, without actually connecting it to my printer yet (since it's in the middle of a print). It seems to work just like it should, right off the bat. I simply connected the three plugs to the SKR board as described for the BLTouch, flashed the firmware with BLTouch enabled, and was able to run a probe and see the probe popping in and out, etc.I'll update this if there are any problems with accuracy once set up on the printer. So far, it seems like a great, better value option than a BLTouch.

The device works well.Easy to install.You need to take extra care when lining up and make sure you adjust the Z settings on the printer to lower the head by approx 2mm.If you install and the Extruder dives into the heatbed, Turn off the printer and check the wiring.I had this happen and it was because I had the wires in the right place but they was around the wrong way.

Returned to Amazon, 6 days after purchasing.Had done about 3 or 4 print runs since getting it last Saturday afternoon, this evening turn it on and it just keeps going to a red flashing light with no changes to the printer being made or touched since last successful print.Rebooted printer several times and in all cases the sensor pin never extends anymore during the self test at startup.Garbage

Didn't work. Bought for a new build to keep costs down. Didn't work at all. Tried it on two other printers that both have BLtouch's on and it didn't work on them either. Sending back and buying the real thing.

It is faulty

Thank you, all is working well

Was a bit fiddly to setup which was expected but there are plenty of guides and people that have upgraded who can help in the 3D printing community. Works exactly as expected and for the price I cannot complain at all.