BTF-LIGHTING 5050 RGBW 4in1 LED Strip RGB+Warm White(2700K-3000K) 24V | 5m 60LEDs/m White PCB IP30 Not Waterproof LED Tape for Indoor Lighting not Content Controller Power Supply

Seems good quality and the LEDs are nice and bright. Can be cut into sections of 100mm which contains 6 LED chips. The strip is 12mm wide and a full roll on at full brightness uses about 3.5A so make sure you buy a big enough PSU. When cut into sections and run off a DMX decoder you can achieve some really good effects with this strip.

The length is amazing and the brightness is perfect very easy to install comes with only one warm color range light still the quality is amazing

Colours are very intense, but after carefull installation into aluminium profile on led coving a section of the red channel has stopped working within days of installation. It's all stuck down so I can't remove it to return, to fix it I would just solder in a repair section.

Tutto perfetto

Apparentemente fatta bene ma: PRO: 1. piuttosto luminosa se piazzata in contesti di retroilluminazione ( scrivania, tv, mobili,…) 2. È solo la strip, quindi grande libertà di scelta degli altri componenti (alimentazione, controller, remote) CONTRO: 1. (GRAVE!!) La cablatura non è conforme: i colori sono disposti nell’ordine GRBW piuttosto che RGBW. Necessario quindi invertire i cavi R e G in fase di installazione (per attaccarla ad un controller o ad un’ altra strip) 2. Del bianco caldo non c’è traccia minimamente! 3. Scalda parecchio 4. Biadesivo non 3M che non mi da molta fiducia nemmeno a guardarlo. Credo sia assolutamente necessario un profilo o altro nastro/colla…vedrò quando lo piazzerò 5. Piuttosto costose (sono cmq una cinesata) Speriamo nella durata… per il costo che hanno mi aspetto almeno 100 anni!

Ich bin mit den LED Streifen sehr zufrieden, sie sind Hell und die Farben passen auch. Ich habe sie genutzt um bei meiner TV Wand einen Hintergrundbeleuchtung zu bauen

Good: Bright in all colors. Wired on both ends of the tape, one male & one female connector. Comes with a spare M connector in case you have to cut and daisy-chain it. Ran cool in my initial 30-minute test. Tape on back sticks well (but see below.) Bad: The double-sided tape on the back is not applied correctly; every foot or so there is a 2-3 inch span where the light tape lifts off the sticky tape, requiring you to cut the sticky tape to make it lay flat and leaving un-stuck stretches. It didn't matter much for my application, but would have if I'd used this for e.g. under-cabinet lighting. Bottom line: The product itself seems pretty good, although I haven't done a proper burn-in test yet. The sticky-tape issue, however, turned a straightforward application into a difficult, tedious job. Five stars, but the sticky-tape thing came very close to costing it that fifth one.

Installé en corniche avec profilé et diffuseur. Rendu très beau, installation simple avec les connecteurs rapides. Gestion via passerelle DMX intégré à une domotique. Livré en 2 jours ouvré. RAS.