DUJISO Leather Working Knife with Wooden Handle - DIY Leathercraft Cutting

This is a skiving knife but if you want this to work like the top name brands , you’re mean to do some sanding .. on the bevel side facing down. You’re shooting for a 10 dreg angle . Blue tape a round pice of nylon on the handle so you can redress that angle. Start with 80 grit , marker up the blade . I did mine on a granite tile and the area that I’m sanding is only touching the blade . The nylon spacers is wrapped with blue tape . It takes time to redress the angle . Once that has a burr on the opposite side switch to 150 grit and repeat the process. Use a fine grit stone to clean the burr off the back . Then go to 180 grit so the same . After I got to 220-320 I started using the sand paper on the bevel on the back. I used water on the wet/ dry sandpaper. I went all the way to 15000 grit . Front and back , make sure on the back you hold the blade flat to the sandpaper. Keep the same amount of pressure on the blade fro start to finish. Onlt the cutting edge of the blade will be on the sandpaper . Once you get to 15000 grit do it bevel side and back 3-4 times . Your done wit the sandpaper. Now on to the strop board buy one or make one and use green stick compound on the smooth side of the leather. 20 times on the bevels side and the same on the back holding it flat . Then 15 , 10, 5 ,1 . It should be very sharp . Now this will shive shuck or thin leather , I’ve done four knives the cheap ones and a planer blade . Or you can spend the extra coin a buy a higher tagged knife and hit it with a strop and your set. Good luck , thanks for reading my story 😎

Mine arrived sharp as a razor. Other reviewers have mentioned that theirs was dull or chipped. Mine is scary sharp. You can see the grind marks on the edge but it is still extremely sharp. I'll have to be very careful handling this knife.

I’m not going to lie, I expected this to need sharpening as soon as I got it but I was wrong. I used this to trim 9-10 veg tan and it was like cutting through butter, I didn’t even have to strop it. It’s a nice little knife and I find myself using it all the time.

Well made skiving tool...works great for me on leather....& I ĵ⁶.got it mainly for skiving & working with caiman crocodile leather.!!!!

Sharp, has been useful for basic leatherworking projects on several types of leather.

For 10 dollars you could do a lot worse than this knife. When it arrives it had a secondary bevel as seen. It was able to shave hairs on the back of my hand out of the box, but the edge was convex very very slightly. I used a belt sander and made a single 15 degree bevel. Then I used diamond stones to get it down to about 1200, then on to the strop with green compound until very reflective. About 30 to 40 minutes of work to make it hair popping sharp. It is actually pretty nice for cutting out pieces in lay up, but I dedicated it solely to skiving so I dont have to worry about the edge as much. Make a little sheath for it so you dont ding it or cut yourself.

Very sharp-use on heavy leather.

It was not sharp when it arrived and the blade needed done work on sharpening stones. It works better now but definitely it's cheaper steel that doesn't hold the edge for long. Good tool if you're in a bind and need something quick.

Tres bien

very sharp item

Bezüglich anderer Rezensionen war ich zwiespältig, das Ledermesser zu kaufen. Einige berichteten von gravierenden Mängeln an der Schneide, was mich eher abschreckte. Was mir geliefert wurde, war durchaus völlig in Ordnung, daher nehme ich an, bei dem Produkt gibt es "Montagsmodelle", was in meinem Fall glücklicherweise nicht so war. Das Messer machte beim auspacken einen wirklich soliden Eindruck. Überrascht wurde ich von der Klingendicke, die 2,5 mm beträgt. Die Schneide ist sehr sauber geschliffen, ich habe versucht den Winkel zu bestimmen, durch die kurze Schneidfase leider schwierig. Sie sollte ungefähr bei 25 - 30 ° liegen. Geliefert wurde es mit einer ordentlichen Gebrauchsschärfe. Zum schneiden von Leder ausreichend. Für bspw. schneiden von Radien würde ich es nachschleifen, was die saubere Klingengeometrie entsprechend leicht macht!!! Sinnvoll ist es, der Klinge vor Benutzung eine gute Schärfe zu verleihen, es also leicht nachzuschleifen und auf einem Abziehleder zu finishen. Bei sinnvollem Schärfen (empfehlen würde ich eine Schleiffvorrichtug jedweder Art) sollte es lange Freude machen. Empfehlung meinerseits.

Il fait le travail qu'on lui demande et le manche est plutôt agréable au travail. Bon rapport qualité prix.

Coltello che arriva perfettamente affilato, e per quello che lo ho usato finora mantiene bene l’affilatura.