PoiLee 5pcs Capacitor 10000uf 25v 18X35MM, Radial Electrolytic Capacitor 25v Low ESR

I tested 2 to verify my shipment was real and not counterfeit parts. With a DVM and clips, attach a 10 k 1% resistor and charge with a 9 V battery. With a stopwatch, measure the time to drop 9.00 V to 3.31 V (1/e) and multiply seconds by 100 to obtain uF. I observed 95 seconds = 9,500 uF for both caps. I have run these at 20 volts with no excess leakage. A cap this large with low ESR it will put a strain on the rectifiers, so I use a 5 A rated diode. I will rate some other caps...

I will use them later in the week, mean while they tested OK. Will wire them into a new circuit to see how work later. Thanks

One had a sharp dent about 1/4 the way into it but it still measured as others for capacitance.Not sure how the working voltage would be affected.Would hesitate to install it into anything.

The capasators were fairly close to the 10K advertised capacity. They ranged from 9.3K to 9.75K. Overall I'm very pleased with the quality of the components. I'm using them in a 15.5VDC system and they are performing very well.

Used to replace a capacitor that went bad in my Yamaha receiver. This 25V capacitor is physically the same size as the 16V unit it replaced.

They are beefy 10000uf caps. None have failed in my applications. Haven't put them on a cap tester to see the accuracy yet.

As described, good items thank you.

One of the best uses for this high capacity storage is for power supply filtering and clean up of the AC component still riding on the rectified DC output just add this capacitor to any rectifier circuit for a smoother DC output