YakGear 01-0096 Standncast Outriggers (Gen II)

Works as intended and stabilizes my Coleman canoe. Had to make brackets to mount but I expected that. On first test I had my wife ,me fishing gear battery and trolling motor in canoe and stood up and rocked the canoe and can tell it helps a ton would recommend. I like that they snap in and have a locking lever to take on and off for transport.

Made my ascend 10t so stable I can walk to the front. Put them in the front for when you stand it'll have better stability and the connection to the floor to the walls is more stronger. Mounted with the included wellnuts, sometimes they pull out a little but just re tighten

I think any outriggers, be them cheap inflatable or these, are going to give roughly the same stability so I feel this high price boils down to high quality parts and features that will hold up in salt, unobtrusive and well designed with lots of ease of use features and follows the sleek nature of a kayak. If a larger 6 bolt base was available it would be five stars. I would absolutely buy again. Pros: Even though they’re expensive, I feel the quality of the parts as well as fit and finish warrant it. I was skeptical but they are well thought out and executed so now that I have them it’s not an inflated price imo. For example, the insides of the tubes are painted which is a well thought out detail and they should handle salt for a long time. Superb running stability on my Pelican catch 100. They handled 1-2’ waves well enough that I’m now more comfortable going out on rougher days which gives me a lot more chances to go out and enjoy. I didn’t notice any sign of drag, my speeds remained the same as before installing. Over joyed with standing stability, I was able to sidearm cast and lean over the edge all while reaching down adjusting the trolling motor speed/direction, all of which could get sketchy sitting down without these. I appreciate the low profile more than I thought, these are barely noticeable with a clear view what’s in front of you (if you plan to mount them forward) and they’re not distracting at all. They look and feel like a natural extension of the kayak The mounts are very sturdy and convenient which I’m sure was a large part of the cost as Railblaza isn’t cheap but they were the right choice here. It’s basically one button to remove them yet it is very secure. Simple to install, just take your time, directions are clear english with good attention to detail yet easy to follow. Cons: I feel they should offer larger mounts with 6 screws to give more surface area attached to the plastic so it doesn’t flex so much, either as an option or offer an adaptor. I don’t feel it’s going to rip through the plastic or anything but something I plan to address in future trips. It’s a high end product that lives up to its high end price

Exactly what I was looking for for my Kayak. Does the job without interfering on my paddling!!!

Works perfectly. Easy to install

Issues I've had. 1. The Plastic mounts are made of a cheap hard thermoplastic making them prone to shattering especially when the bottom is filled with holes. It should be one whole piece of plastic. Or make it out of aluminum alloys. 2. The riggers adjustment knob teeth aren't fine enough so there's really no fine adjustments to the angles. You can make in work tho. But one float is always going to be floating higher out of the water than the other. Probably by about 2-3 inches, but if you lean to one side it will hold you up. 3. I needed these as I did the Stadium seat upgrade which replaces the low sitting kayak seat and places you up about 4-6 inches higher so it made the kayak almost to top heavy to use.. These did improve the stability of my kayak though. 4. No I could not stand on my kayak with these outriggers, Maybe a bird boned dude could at 145-165lbs but me at 260 could not

My weight 305 pounds plus the weight of fishing gear, so I am about the weight limit capacity of my kayak which is 325 pounds; so my kayak felt very unstable and one time I tipped over in a springs. Most of the time I go fishing to lakes full of alligators near Tallahassee, so I decided to try to improve the safety of my kaya installing the stabilizers, after a couple of days of research, I decided to buy the Yak gear ones, installed them in 30 minutes, and went fishing the next day. Wow, what a change, my kayak feels now very stable and secure and I do not feel any difference in dragging. I recommend this product 100%, very good quality and very easy to install, and very important also, 100 percent American made.

The outriggers are perfect. They were easy to attach and work great. While I was new to a kayak and afraid I would tip over, the outriggers provided the stability needed.

No me gusto la forma de fijarse al casco del Kayak; esa fijación debería de hacerse con tornillos y con tuercas. El sistema de fijación y que viene es muy débil

Fits good. Looks good

The product is great and works amazing (other then missing some screws), but YakGear Customer service is not great at all. When purchasing the product I paid for shipping, then the when the freight arrived I was charged for another shipping cost. No mention on the anywhere that there maybe additional shipping costs. The shipping company would not give me the product unless I paid the extra costs. YakGear did not answer any of my messages sent. I have called there number and left many messages and no call back. I had to get ahold of Amazon, their customer service was great and got me my product. Amazon Customer service could not even get a hold of Yakgear as well no how matter how many phone calls, emails and messages where sent no reply back at all.

Set was possibly used so that might be part of the reason but came half together one side drilled the other not so much an the elbows do not mirror each other so no matter the alignment they do not match looks ok if you squint lol moved a few screws so hopefully its functioning