4pcs Tie Down Anchors Truck Bed Side Wall Anchors Fits for 98-14 F Series, for 99-13 Silverado Sierra, for 95-19 Ram but 09-19 Ram Rail Cap Cut Required

Excellent quality retractable tie-down points. Fit perfectly into stake pockets on my F250 pickup bed. Simple to install. No worries about dropping screws or parts. You remove the 2 clamping screws. Insert the tie-down bracket into stake hole then lift up slightly on u bolt tie-down. Thread screws into bracket and unit is clamped into stake pocket. Excellent quality. Very pleased. Easy install.

I haul a lot and need good tie downs. My F150 only had a few tiedowns and I needed higher ones as well. These are perfect. They come tightened so you first need to loosen them all the way. The metal plate cantilevers into the hole and swings under. Lift the bar drive the screws. That's it! if the bar does not move well, you may need to loosen slightly. I also found it helped to spray them with WD40. Exactly what I needed.

I have a 1996 Dodge ram 2500 and when fitting these which is very easy, they don't clamp down so they move around, the way I fixed this was to use a hammer and bend the ends a little so they are closer to the top. Just small adjustments made all the difference to get them to fit snug and tight with no movement. Without doing this there would be rattles so not a perfect fit is you don't have the top rail lining on your truck.

I've had a few sets of these installed on a few of my pickups. They're an easy way to add tie-down anchors and dare I say a stylish look for your truck.

Had on my truck, no rain, started rusting, thought stainless steel.

They're okay if you don't mind a little rust. They work as intended.

No instructions included. Loosen screws until they are almost out of the threads. Lift up on metal bracket and slide black plastic piece into hole on truck rail. Slide metal piece with lip into the grooves on side of hole. Might need to lightly tap with flathead screwdriver to drive down. Tighten side closest to truck bed halfway then tighten the other side. Alternate until both are firmly snug. Do not loosen screws so much that they come completely out of threads or you'll have a difficult time.

These are great until they started to rust - right away. They don't look that great anymore but they do the job they were intended to do.

Ajustan muy bien en una F150 2010 y fácil de instalar.

سهلة التركيب وقوية

Se ajustó perfecto, tengo una F150 2011 y quedo muy bien

En la publicación indican 4 anclajes y solo llegaron 2