ANVISION DC 24V 40mm x 10mm Brushless Cooling Fan, Dual Ball Bearing, 2 Pin

Needed a small mountable cooling fan for a project and stumbled across these in my search. Bought one and liked it some much a bought a few more to have in my supply drawer for other projects. They're quiet and push a good amount of air for their size. Motor bearings seem to be good as I've used a few of these with no issues so far. They just work and work well. Good part, highly recommend.

I purchased this to upgrade the fan on my Ender 3. I chose this fan because it was 24v, and would be the easier to install compared to a noctua. The I measured the decibels of this fan compared to the stock Ender 3 fan, and found it to be about 5 decibels more quiet on average (measured 1 inch away, and 1 meter away) Overall a good purchase if your stock Ender 3 Fan has broken and want to go for something a tad quieter, same airflow, and directly replace. I also purchased an Orion 40mm fan, which is also 24V, and it is a lot quieter than the anivision one, though has a lower CFM, uses different screws, and doesn't come with a 2 pin connector.

This fan is significantly quieter than the stock fan on my A350 power supply. I printed a modified backplate and this fan fit perfectly. Just be sure that the pin wires match the correct spots on the connector. I had to swap the red and black wires in the included 2 pin connector to work with the PSU.

Bought this to replace the fan in a reptifogger. Fit and worked perfectly. Saved me $60. Unfortunately the ultrasonic fogger went out a few weeks later haha

Purchased this fan to replace the extruder cooling fan on a Creality Ender 3 Pro 3D Printer that completely died. I selected this fan because it has ball bearings, not sleeve bearings and because it comes equipped with JST-XH type 2.54mm 2 Pin female connector. To make the connection with the original wires back to the control board, I purchased a JST-XH type 2.54mm 2 Pin male connector (Amazon #B07YKHV46N) and 3/32" red & black 3:1 heat-shrink tubing (Amazon #B08KLSGKTG). A little soldering and heat gun action gave me the matching male connector in place. Reassembled everything without trouble. Fan works great though it does make a tiny high-pitched whine that the original Creality fan did not have so I subtracted 1 star. Still, since this fan is always on when the printer is on, I am hoping this fan lasts a long time with the improved bearings. Regardless, if this fan does not last longer, at least it will be easy to replace now that I have equipped the printer with the JST-XH type connector!

Good fan, slightly quieter than original Ender 3 fan. Plug and play so installation was very simple. I will get, only if another fan fails. Not really an upgrade.

Works just fine cooling my DIY 3d printer, just a bit too loud for the task will keep for another task when it comes along.

The stock fan on our 3d printer was so loud!. Replacing it with this fan has been awesome!

Weak airflow, only 0.024A (0.58W) instead of 0.06A

+++++av 5

Easy to install. The pins fit on their own. It works.

Bon acheter pour garder juste le câble pour éviter de coupé celui d'origine Remplacement VentilateurNVR par le Noctua NF-A4x20 FLX, même conectique donc que du bonheur je vais pas l'évaluer car c'est le meme que celui d'origine ou jétais a 58 db Acheter uniquement pour la conectique

Livraison ok et produit parfait