MOOG K80079 Suspension Stabilizer Bar Bushing Kit for Ford Ranger

They fit perfect and were really easy to install on a 98’ Ranger 2wd. It took about 20-30 minutes total.

Installed these on my 2001 ranger as part of a partial front end refresh. They are of good quality and fit the stock sway bar perfectly. I have also used this and other moog components on my 1996 bronco with good results. Would recommend.

Never had an issue using Moog products, work as they should. This was for a 27mm size bar which fits and works as it was designed to do.

Llego exactamente lo que pedí, un par de bujes de barra estabilizadora estoy conforme.

Great

Good product

Moog quality.

i have a new truck! ok, not really, but it feels like it. only a few miles on these bushings, so i can't speak to the longevity. i'll post later if any unexpected changes. i added a touch of silicon paste to the inside surface - maybe they won't wear quite as quickly. for me, the installation was pretty easy. if you have difficulty getting them open enough to slip over the bar, use a screw driver, paint scraper, chisel... these are 27mm bushings - measure your sway bar before purchasing. this is a 15 minute job with big payoff for not much money. it might even fit the "annual maint schedule" category if you drive a lot of miles. four bolts, in and out, done.