SAWbird+ NOAA - Premium SAW Filter & Cascaded Ultra-Low Noise LNA Module for NOAA Applications. 137MHz Center Frequency

This filter has a feel of quality about it and it has helped improve the NOAA weather images I can receive using a simple horizontal V aerial. Works best with the filter located at the aerial and powered by a biased T. But NOAA satellites no longer operating.

This performs pretty much as the datasheet that Nooelec publish. Gain is high, and the passband follows what they say. It's very sharp on the lower side, providing strong attenuation to airband and FM broadcast, but rolls off more gently on the other side, still allowing some of the very strong 153MHz pager signals through. Realistically, I'm not sure the LNA is needed. I get reasonable signal strength for NOAA satellites with just a V-dipole. The high gain means I'm brining up the noise as well as signal, and it's overwhelming rtlsdr dongles. Just a filter might work better for me, but your mileage may vary.

I purchased this because it's a recommended product on RTLSDR forums and sites for downloading the weather satellite footage from the NOAA sites over using a generic wideband LNA I have yet to o gain a good image. This isn't the product it's just me because I'm relatively new and still learning. The sawbird filter has an adaptive draw I wasn't powering mine through a USB socket or dc jack I used a bench power supply Initially I had the voltage set as 4.5v however I discovered this was actually too much ( but within range) and it wasn't applying much gain I reduced the voltage down to 3v and it's usage went to 0.35A and then it got about 30db gain in signal So it does work. However I need to take my equipment outside and add grounding straps because I'm getting a lot of electrical interference I also need to bukd a better aerial. Setup filters properly find the right station etc etc

I started this hobby with just the sdr and a dipole, it worked great producing incredible NOAA APT images. I thought using this sawbird would make them even better. So i bought it, hooked it up probably, and what did i see? I saw nothing on the waterfall, i removed it from the setup and it was back to normal. It actually makes the signal worse!!! Investigating the SAWBIRD online i found many many people with the same results. I also found that a majority of users reported that i did help, though not much, and from 1 week to 1 month after using it, it would just die. Im not sure on the electronic technicalities inside but many people found that it has 2 flaws.

Does what it says, I have my RTL - SDR NSDR SMArt (black) on automatic gain -10 with a DIY RQFH Antenna (Reasonate Quantifilar Helex Antenna) running Raspberry Pi NOAA Weather Satellite Receiver by haslettj instructions on Instructables. It's a well worth project, and the end results speak for themselves. Already ordered the NooElec SAWbird+ GOES - Premium SAW Filter & Cascaded Ultra-Low Noise LNA Module for NOAA (GOES/LRIT/HRIT) Applications. 1688MHz Center Frequency to complement the NESDR SMArt XTR (silver), for the next satellite educational project, just need to get a Grid Parabolic Dish Antenna, which seems a bit difficult to get here in the UK for a decent price.

Did make a different. When was recording NOAA satellites (NOAA 15, NOOA 18 and NOAA 19) without LNA module I used to get 3 - 4 good images per week. When I connected this I’m getting 4 - 5 good images a day. It does need DC block. I’m using double cross antenna in a loft.

Overheated and never came back on. There is no led showing, psu has been checked and verified, no luck . Tried to contact NooElec, no luck at the moment. Lasted about 2-3 Months, was not really impressed then , even more not impressed. Can'e believe I spent nearly £50 on an LNA for 3 months use. Very dissapointed, I will be looking elsewhere for a more reliable device, waste of my hard earned cash. Research first before you buy, buy one if you have to, other than that, forget it.

Improves reception of NOAA 15 somewhat but does very little to eliminate pager signals or any other QRM caused by heavy radio traffic in my area of the UK which affects NOAA 18 & 19. Tests proved lowering the antenna and using broadband LNA much more affective. Item returned.

Low-noise amplifier with the filtering lower-cost SDRs need for best results. Nicely packaged.

Gebruikt voor de ontvangst van noaa weersateliet niet lang plezier van gehad eerste unit werkte niet bij aankoop weer een nieuwe besteld deed het na een dag al niet meer. Vind het een slecht product behoort gewoon na behoren jaren te werken .

Absolutely awesome piece of electronics 💯👍🇦🇺

I was having problems copying NOAA weather satellites due to nearby strong signals. This SAW filter and pre-amplifier has completely eliminated the problem. I was able to place he Sawbird unit in a weatherproof box at the antenna and power it through the coaxial cable with the bias-t feature. It works great.

Cumple su función perfectamente