Item Package Quantity:4 About Jack Pad Adapter for Jack Stand Universal Rubber This is a must have product for any professional or home mechanic. Many car and truck Repair Manuals will tell you to jack up your vehicle by the standard jack points which can be on the pinch seam weld or the frame rail.Often times for vehicles too low or in an emergency situation the factory side jack points need to be utilized. Protect your frame rails when jacking up your car with these jack pads.Without proper support the thin rails bend and cause future use of them to be problematic, and even unsafe if the jack cannot secure to the jack point. Durable and resistant to damage, it will keep the chassis rails from getting pinched, bent or broken.Polyurethane is too soft to harm your vehicle's metal yet rigid enough to support it.Friendly Note: Please verify dimensions and ensure fitment to your vehicle.Jack Pads will have a little bit rubber smell because of the heavy duty rubber material, please put it in the ventilation room for some days.
T**1
Jack pad adapters work
I ordered the jack pad adapters because the 2-3 ton jack stands metal lift arms did not accommodate my MK4 Jetta underneath carriage. The thick rubber pad adapters easily mated to the jack stands and allowed for a perfect alignment with the the vehicle contact points (safe-zero damage). Without the adapters I would not have been able to use the stands. Recommended for VW Jetta's.
J**R
Good choice for a Toyota
Pads appear to be made of sturdy material. I just tried them out on a set of new jack stands on our RAV 4 and these pads are the first that have a groove deep enough that the vehicle's crimp flange barely touches the bottom of the groove's rubber to do any damage once the jacks are holding weight. I've gone through two other company's pads where the flange literally cut the pad in half because the groove was not deep enough.
J**L
Not bad, tends to stick to pinch welds
These are ok. My Honda has folder over pinch weld jack points that are a little wider than some. The pinch welds get wedged into these jack stand pads, so I often have to pull the pads off of the jack points after I take the jack stands out from under the car. I think the extra stress will probably shorten the life of these pads. Overall fine. The jack stands are Duralast 2 ton.
M**N
They do the job
Fits well on my Prolift 3 ton jack stands. They are soft enough to not damage the paint/undercoat, but they were stiff enough to not be immediately damaged. I have only used them twice so I am not sure of long term durability. I will update sometime in the future on how they hold up. So far I would recommend.
T**S
Fits the 3-Ton Torin Black Jack like a glove
The 2003 - 2009 Toyota Corolla repair manual - under VEHICLE LIFT AND SUPPORT LOCATIONS Section 3. (b) specifically states: Use a safety stand with a rubber attachment, as shown in the illustration. And yes, there's an illustration depicting the rubber attachment.
S**K
Work well for my Craftsman 3 ton jack stands
Use these for Craftsman jack stands when lifting my 2015 Jeep Grand Cherokee.Great for when using stands at the pinch welds and these also keep from scratching the undercarriage.Shipped quickly. No issues.
M**E
Holding up well!
These have held up much better than another brand I tried. These are thick enough that the pinch welds don’t carve through them. Both of my vehicles are well over two tons each so they have been tested under a lot of weight.
3**R
Great fitment
I needed something to put in between my car and my jack stands. At first I was going to use hockey pucks but I’m glad I stumbled upon these. They fit great on my jack stands and protect the pinch welds on my car.
Trustpilot
1 month ago
4 days ago
