Coax Cap Cover, 75 Ohm Terminator, 10 Pack, Coax Terminator Caps for Ports on Splitter, AMP, Coaxial Cable, TV Antenna, Wall Plates, Booster

I purchased these terminators for use with a television over the air antenna combiner. These are mechanical, have no electronics, and no moving parts. The serve one function, which is to terminate cable connections in order to prevent signal loss or interference. They are well made: sturdy metal, properly machined threads, stiff conductor wire, smooth and evenly plated surfaces. I needed them because I swap between one and four indoor antennas on and off the combiner, which leaves up to three ports open at a time. I haven't seen a big difference between using them and not using them, but I can see the difference. Every improvement on a television picture. Using them is easy: Line up the stiff wire conductor inside the terminal with the hole in the center of the insulator in the port. Be sure to line them up straight. Push the terminator toward the port, inserting the wire, until the terminator just touches the port. Then thread on until tight. I'm going to order some push-on type connectors to attach to these terminators so that I can just push on and pull off when changing antennas. That would make these perfect. I didn't rate the "waterproof" because I use these inside only. Also, these are a great bargain at the price. Buy them for a better view (and better stereo, too).

Great product.

The quality of the builds was great and they all installed without issue. I didn't measure the impedance of these but assuming they are accurately described, it will limit the reflections on my open coax ports. Does it help with signal? Maybe. Can I tell a difference? No. But that's the beauty of a digital signal if you have enough of it, it'll be clear. These might help you if you are on the very edge of having a good signal or not.

Quality items. Look great

It does what it is intended to do. I love that it screws on tightly and it doesn't come loose when my toddler starts messing with it. 5 stars.

These caps cover unused RF Coax connectors. If you don't put a cap on an active but unused RF Coax connector, you will lose a slight bit of signal.

These caps are well made and function perfectly for terminating male F connectors.

They are fine, I bought because they were the cheapest option.

Worked well. Easy to use. Saved me a lot of money

Work well.

Just what I was looking for.

Everything was perfect 👍😀.

These are inexpensive and do what they’re supposed to do. A lot of the pins were bent, but that didn’t hinder their ability to work. I just straightened them out before use and they were fine. Very straightforward product- arrived in no fuss packaging.