HPDMC4500psi Yolk Fill Station for HPA Tanks - High Pressure Gauge - Aluminum Alloy Refill Adapter - 36in Teflon Hose - DIN Valve for PCP Paintball Tank Charging System (Red)

This unit works perfectly well at a Much lower price than many offerings. You Must have a good O’ ring on your tank and get all slack out of the yoke. Pay attention to and be careful with the valve seat. If you scratch or ding it Lapp it with very fine stone back to a mirror finish.

I bought this to refill my Benjamin Armada 0.25 (BTAP25), using a HP 100 cu Steel scuba dive tank with a YOKE valve.Pros: * It works. * Quick attach/detach to the fill adapter assembly. * It has a manometer. * It has a Bleed Relief Valve. I did not have a problem opening the valve even at 3500 PSI. * The length of the hose is adequate. * Well built.Cons: * NoneOther thoughts: * The hose could be more flexible. * It was pretty hard to use the quick disconnect during the first 20 refills. * It would be nice if it came with something to protect the air hole when it is not connected to a yoke valve. Like a scuba dive regulator 1st Stage Dust Cap Rubber.

Was quite easy to add to a scuba tank to fill my PCP airguns. Worked flawless.

Works good and fast, to fill my Benjamin Maurader with a scuba tank. The pressure release valve is impossible to turn under pressure without pliers. It would be better if it was more like a wing nut or something you could actually turn with your fingers. The small knob is just too tough.

Was a gift for my husband and he absolutely loved it. Plus it was a good price

Great product at a great price! However, the connector to the PSP gun keeps popping off and the o-ring comes off as well. Any ideas on how to keep the connector from popping off? It is pretty dangerous the hose flying around when it pops off. Help or ideas would be appreciated. Thank you!

Maybe this is ok for quick fill small jobs, but i've had problems with using this for extended periods of time filling larger bottles. I have my own compressor and was using this yoke to fill an 80 cf bottle. The first time using it the o-rings blew out at 3000 psi. I took it apart and found out that the set screw had slag on the inside of the cavity and o-rings was damaged when assembled at the factory. So I removed the slag and replaced the o-rings, and did a test pressure run and the new o-rings started leaking at 3500 psi. I replaced them again and started working. But i haven't did a upper limit pressure test because i don't want to waste the o-rings. Maybe i got a defective unit, but since i won't be filling more then 3500 psi i'm going to give it a little more time before purchasing a better yoke.***UPDATE*** I was able to get this working as it should. The o-rings that were originally installed in it was a size -010 which is a common scuba o-ring. I replaced them with a metric 10x6x2 o-ring, which is slightly larger than the -010 and this allowed it to seal. And i also drilled a hole in the yoke tightening screw, and installed a 3" 1/4 bolt to use as leverage so it will seat tighter. And after doing this i'm happy with the item.

Had received fill valve , with defective bleeder right out of the box . A little miffed cause now couldn't charge rifles. But the vendor was quick to make it right , offering to send a new one ASAP! I'm impressed, very impressed. Will deal with again in the future for sure .

He usado el producto para llenar tanques de buceo y ha funcionado de maravilla, solamente tuve que adaptarle un conector (costó alrededor de 30 MXN) y listo.