WIIBROOK 50pcs White Cable Clips, Adhesive Cable Organizer Cord Holder, 0.56 ...

I install stairlifts and wheelchair ramps for a living. The stairlifts have battery chargers that are permanently connected to them. The smaller DC line can be stapled to the wall or baseboard, however, the A/C wire is too thick to effectively staple. These cable clips fit the bill, nicely. They stay stuck when applied to a clean, dry surface and are easily removed without taking the paint off or leaving adhesive behind. One note is, that they are reusable. Do not bother attempting to reposition them. If you must relocate one, throw the original away as it will not stick well once removed. Simply discard the original and use a new one! I will be ordering these, again and again.

I would not put more than one cable on these. The adhesives don't seem super strong but work great for my one car project. I've been using with the Xmas and Halloween decorations to keep the cable from the floor and our kids and have worked great so far. The decorations look neater, clutterless and out of the way from my babies. For one of our light that was too tight it fell off, so had to make it a little so it did not pull the hook.

These do a nice job of managing cables and wires. And removal/remounting of wiring is easy since these never really fasten closed - they just have a flex opening. And the adhesive is quite strong, in fact, place them carefully, because once in place they're hard to move. I removed one star for the backing plastic over the adhesive base; one needs to have the fingernails of Cassandra, Mistress of the Dark just to get the backing off of each one. Perhaps this is the price one pays to have adhesive that remains cemented throughout the life of the build. I didn't have to remove any, but I suspect that would have involved acetone and required the removed clip to be replaced. That's a relatively small deal since the larger concern is integrity of the adhesive. I used to install avionics and wire harnesses on aircraft. Aviation has similar wire bases as these for this purpose although those require a separate tie strap to hold wire bundles and cables. So there are many times I would have preferred these over what was available to me at the time (for those in the know, these would have had to have FAA approval for that use). Speaking from the perspective of an experienced installer, I found these to be very useful and clean. I still have quite a few left after the build, otherwise I'd say that I would buy them again - even though I don't have Cassandra's nails.

Nice and small little clip on pieces. I took two photos for reviews.

Good bang for the buck, but didn’t stick well, especially if exposed to heat (I use them in car).

I’ve used these clips across my workspace, living room, and car. Here's the real deal: ✅ Pros - Strong Adhesive: Once you stick it, it stays. I cleaned the surface first and waited a couple hours before inserting cables — no slipping since. - Clean Look: Matte black finish blends into most setups. Doesn’t look cheap or bulky. - Flexible Use: Fits USB cords, phone chargers, speaker wires, and even some thicker cables. Great for keeping cords off the floor or dashboard. - Generous Quantity: 50 clips is more than enough. I organized three rooms and still had extras. ⚠️ Cons - One-Time Stick: If you misplace one, it’s done. You’ll need a fresh clip. - Not for Heavy Cables: Anything thicker than 0.26" might not hold well. - Surface Matters: Doesn’t stick to textured walls or dusty surfaces. Smooth and clean is key. 🛠️ Final Thoughts If you want a no-drill, no-fuss way to tame your cable mess, this set delivers. Just prep your surface and be precise when placing. For lightweight cords, it’s a solid fix.

Edit***after a few months, the adhisive is not strong. Anything heavier than a phone charger cord has fallen and is droppy again. Clamp is small but I could double wind a phone charger and holds a thicker cable with ease. Used lots because I have many cables for my gaming desk. Haven't tried to remove yet but they are holding and makes hiding cables easy.

I've attempted to use these indoors to run thin wires along walls. While the adhesive (looks like 3M VHB or some other pressure-sensitive adhesive) sticks just fine and can be removed* with little or no damage, the clips themselves snap off the base with little warning. I don't know why they're so embrittled, but it's as if they're made of the absolute lowest grade firm plastic or were exposed to ultraviolet light for long periods of time. With Amazon, you're often rolling the dice on any one particular product, especially from fly-by-night brands, usually from China. Try another cable clip because, out of the handful of cable cips I've purchased, WIIBROOK is the only brand whose plastic structure just break apart**. * For removal, in addition to an gentle adhesive remover like Goo-Gone, I strongly recommend getting one of those plastic "razors" - they make it super easy to remove gunk without damaging, sensitive surfaces like wood. ** Before I get accused of putting too much tension on these clips, I'm litterally talking about the clip breaking free from the base (while the base is still adhered) merely from a, thin, static iPhone cord just being held by gravity. I'm not yanking these things or pulling thick insulated ethernet cable through them.

Good clip size and decent build quality. Unfortunately for me I tried sticking these to dashboard material and that surface is like Teflon if you don’t prep it well. Probably user error but the clips stick well to other surfaces.

Very cheap price and the product itself is alright. The red protective cover for the double sided sticky material is super difficult to remove. It works great for smaller cables like for phone charging but larger one like HDMI, ethernet, or larger laptop charging cables don't fit. And it'll rip paint off your wall, so stick it on your table instead

Regular se si agarran pero con el tiempo se caen

Nice clips and good quantity for the price. Adhesive is really weak and bad. I would use a high quality adhesive or glue if you want these to remain in place permanently.

Did not adhere to a flat surface sufficiently, would not recommend.