WENHSIN 10Packs 4-Pin RGB LED Light Strip Connectors 10mm Unwired Gapless Solderless Adapter Terminal Extension

These work pretty good. I can’t tell the perfect part because my LED lights are bought from a 3rd party on here and they are smaller than the prongs used on these connectors so it’s been a challenge. May need to get a Soldering kit for my circumstances! They are also cheap (

I have a Kasa led light strip and part of the light strip did not light up. I cut out the part of the light strip that didn't work and used this connector to connect my light strip back together and the light strip now lights all the way up.

Depending on the one you have it works perfectly fine. Or it doesn’t work that well. But there very easy to use.

The product works as it showed the only thing that I have a problem with is when you pinch them close they don't always stay closed I had to use a little bit of nail glue to keep them locked closed

These connectors are difficult to pry open and the pick that comes with it is useless. I was able to open them using a micro screwdriver but even with that it was tricky to open without breaking the tab that holds the connectors closed. Once they're opened inserting the LED wire is tricky as well so my advice is to have the LED lights turned on when connecting the wire to the connector as you're likely to find that they're not working after you close the connectors. Having the LED lights turned ON will allow you to see if you have a good connection. Don't worry these are low voltage. The instruction is not very useful so here are the steps I took to connect the wires: 1. Once the connectors are opened, the trick is to lift the 4 metal silver wires inside the connector so that the LED wire strip can be tucked under them to have tight connections. I used a flat micro screwdriver to lift the metal wires but do it gently to prevent breaking them. 2. Tuck the LED wire underneath the 4 wires inside the connector and then close the connector tab. There's a channel in the connector where you can slide the LED wire. 3. Shut the connector tightly and make sure the tab on the connector snaps closed. This step will push the lifted metal wires down for tight connection. 4. Do the same to the other end of the connector with the LED wire strip that you're connecting. I wish I could take a video but I don't have a tripod. Good luck!

Perfect. Worked amazing

I wish I could leave no stars. These are horrible. The light strip peels away from the sticky back once installed. All the lights feel down in less than 24 hours after installation. I would not recommend this product. JUNK!!!

Easy to put up and connect the lights to. Been up about 6+ months and still holding strong. Not sure how much weight they will hold, they will hold strip lights well. Highly recommend.

Faciles de usar, excelentes

جيد

La semplicità di utilizzo.

Sehr gutes Produkt kann ich nur empfehlen.

Very simple to use, I didn't have any issues popping the clasps open. Took me about 30 seconds to extend my strip light for the extra 2 feet needed. I just scraped about 4mm of the real adhesive away from the strip light so the 4 copper contacts slip under the 4 prongs easily. Nice secure fit, very discreetly extends the lights. Bonus is I have 9 other clips so used one of the others to put together the second set of strip lights I had to purchase for the extra 2 feet. No issues whatsoever, if you're extending strip lights, make sure they are the same brand. I used Tp link (Tapo) smart wifi lights