8PCS Brad Point Drill Bits 3-10mm Spiral Twist Wood Drill Bits Set for Soft, Hard, Veneered and Laminated Wood MDF Acrylic

They worked fine for my project and the value was very good.

I needed metric drills and these will make holes

Photos are immediately after unpackaging, these drill bits have not been used. They are unusable. Cutting geometry is off center and foiling visible shows that the sharpening process was only begun. I would have thought these may have come from a batch batch if all bits in the set didn't have similar issues. Chucking these into a tool runs the potential for damaging the tool or causing injury when you attempt to drill. This kind of issue snaps bits and ruins spindle bearings. Save your money and look elsewhere

Three stars instead of two because of price, but in my mind any sharp cutting edge to be used with wood should not come in contact with metal. These are shipped lose against each other in a plastic box-not good.

i mean they are cheap drill bits.. not the best but might work. not very sharp at all. spend the few extra bucks and get a better set if you need decent bits.. i only needed 1 bit and had to sharpen it right out of the package.

Drill bits need to be centered. Four of the eight bits in this set were not centered at the tip and wobbled too much. A centered bit is critically important for accurate work. I use a machined Know Bit in my drill press and routers to measure for accuracy and runout. The drill press chuck is spot on– these bits were not. They came packaged in a rigid plastic sleeve and were clean and sharp, so I was hoping to get satisfactory results. Not to be. Keep looking.

I didn't realize it at first but after using these periodically for a few months now, I used one on a test drill and saw that the hole was bigger than it should be and the drill bit wobbled in my drill press. If I wasn't using my drill press I wouldn't have noticed, but once I saw that I tried all the rest and all of them except maybe 3 wobbled anywhere from a tiny bit to a lot making them basically unusable for any work that needs to be precise. Otherwise they seem like they'd hold up and come in a nice case, but I'd avoid them either way as the quality control is very bad on these and now i can't return them.

Bought these specifically for woodworking. Right out of the plastic case tried to drill with the 8 and 9mm bits but required way too much pressure. I felt like I was pushing the bit through the wood, not drilling. Would not purchase again.