OptixOptix Hood Scoop Vinyl Overlay Decal Wrap Trim Inserts Sticker Compatible with and Fits Tacoma TRD Sport 2016 2017 2018 2019 2020 - Metallic Matte Chrome Black

Good product. Looks nice. Directions on Amazon okay.Use a solution of 95% water and 5% soap for positioning of the larger decal. Spray the solution on the clean surface. Position the decal with a portion of the backing peeled away. Gently press the decal in to place using a microfiber towel and work from center to the sides. Peel the rest of the backing away a little bit at a time well using the towel to help work out bubbles. Use a Bondo type squeegee to work out any imperfections. Work out any of the remaining soap and water mix from under the decals.The larger decal will go on with no issues. The smaller decal for the scoop may need to be trimmed at the edges as it is a little wide.While the directions say to use a heat gun I recommend against it. It will only melt and warp the decals.

Loved the design and application. I applied this in the spring where it was warm and wouldn't get below freezing since my vehicle is parked outside. That was in March, it is now mid may and you can tell from my pictures it has shrunk and rolled up on itself. The outline of sticky residue from where it was originally installed until now. It has shrunk 1 inch on all sides and looks like garbage. I would advise staying away from this item.

On these vinyl stickers, if they are good they come with 2 sides so you can tape them in place before you work with them.On this you just peal off the sticker and try to place it as good as you can according to their instructions.I installed this using the soapy water method so I could ajust it somewhat.It was still quite a challenge to get straight and I am off about 1/8 of an inch but there is no way to fix that now.Also in the getting out of the air bubbles some of the glue dripped out and got on the top and it kind of stained it a little.I had the heat gun and the felt pad thing to put it on so I had all of the tools suggested.I had to put polish on it to make it look unstained.So, you have been warned. (not so easy)I have to say that it looks pretty good though.

Real easy to install. Watch some videos on YouTube first to learn a few tricks to make it easier. Also don’t apply too much heat with the heat gun near air bubbles (I melted one😬)

Cool OEM decal I love how it was shipped it came with a extra roll wich was pretty nice the product is holding up well had it for a year now and the only thing I've noticed is the edges are pelling up not sure if thats installing wrong or product failure but its not a bad peel maybe like 1/16 in but very weather proof and I live in central Texas lots of sun, drit, gets decent amount of rian and no fadeing at all however take time installing cuase it is a sticker

I was able to cover the entire scoop using a hair dryer (you don’t need an actual heat gun)to stretch the extra (sheet of material provided) around the contours. That’s important because the sun reflects off the edges not the flatter surfaces. I totally messed up the bigger decal that goes around the scoop because I stretched it too much. My bad. I ordered another kit. It’s hard to line it up correctly. The instructions are not written well but the product is good and it can be peeled back and re applied. The sun still bounces off the black but it’s an improvement....okay, I know when I’m beaten. I admit defeat. I can’t work with it cold and it’s too stretchy when heated up. The bigger decal has kicked my tail. I give up. They need a video

It’s shrunk 1/2” and now there’s an ugly residue where the sticker started out. Terrible

Easy to install. Dont forget to use a heatgun.