Sovol PTFE Tube 2.5mm ID 4mm OD, Length 5M/ 16.4ft, with 2 Couplers and Tubing Cutter for Bambu lab X1/ X1C/ P1P/ P1S/ A1/ A1 Mini, MMU3, K1 Max/Ender 3 V3 and Direct Drive 3D Printer

Excellent piece of essential equipment for a 3d printer. Easy to replace existing tube and works perfectly.

All perfect A++

Worked great to extend my PTFE for my X2D printer.

Good for a replacement fits well and only time will tell

This tubing allows the filament to run better and last longer in hot ends that have the tube run through them. I have used on both an Ender 6 and Ender 3. On the Ender 6 the Bowden tube run is so much longer and was prone to have retraction and flow problems when the tube was slightly worn as the filament would drag a bit inside it. Using this tube reduced the friction and made flow and retraction more consistent. It's also a lot better when run inside the hot end. It does not degrade so quickly so printing stayed better much longer when running higher temp filaments like petg. It's obviously not as good as having an all metal hot end or direct drive but it helps (I also recommend using this between direct drives and all metal hot ends as well as I think it has made a minor difference).

Are you getting issues with your prints, clogs or filament flow. You might want to check your Boden tube. If it's bad replace it with this. Simple to install. Remove the old one, measure, cut it FLUSH (to avoid problems) and install. Done. Expert tip - When removing to old tube remove the nozzle and pull it through the nozzle end, it will grab any filament left inside and make sure the heat the hot end when doing thing and repeat the pull multiple times. It's a brilliant upgrade and improves performance on your printer for cheap

Easy fit and tighter tolerance than a standard ptfe tube, this one came with a cutter to ensure a nice square end. Just be sure to measure your requirements for length, not so long its flapping all over but not so short it's being pulled or kinked when your hotend is at the limits. Works well and keeps that filament flowing smoothly. There may be other options but this works well for me, just be careful not to run it at very high temperature or it will off gas. All ptfe does it so its not a fault of the product, just do your research before buying to ensure its right for your purpose.

When one of my couplers gave up (would no longer grip the tube) and the ends of the originally stock tube were wearing out I bought this little kit as a replacement/upgrade to get me back up and running. All works well, although I am a little disappointed that they didn't include any of the little blue clips that are so easy to lose.

Very nice

Ho acquistato questo PTFE in quanto quello originale della mia Ender 2 Pro a furia di stampare PETG si era deformato e creava problemi di stampa. Dopo aver installato questo Capricorn (tra l'altro installazione molto semplice) la stampa è migliorata nettamente. Il filamento scorre molto meglio e la resistenza alla temperatura permette di stampare oggetti a 230 gradi (anche per ore) senza problemi e in modo regolare. Il costo non è bassissimo, ma secondo me è uno dei migliori in circolazione.

i have bought capricorn before, and the one i bought before looks exactly like the picture, however the one i recieved now was not, lower quality and just doen't feel right

Very useful kit

Wymieniłem zużyty na ten i działa. Złączki dobrej jakości. Drobny minus za brak wsuwek blokujących - zestaw byłby kompletny. Mimo to polecam.