Metravi DT-725 TRMS AC/DC Digital Pocket Clamp Meter upto 600A with Auto Ranging

Most clamp meters out there are either AC only or Too poorly made or Too expensive. This fits in the right spot - well made & works for measuring both AC & DC (Current) using the clamp. Apart from the clamp measurements it also fulfills all roles as a general purpose multimeter. The measurement range is automatic. It comes with both a work light & light on the display. I believe the measurements are fairly accurate, the initial reading might not be 0, but as mentioned in the instructions - the measurements are approximately close to the correct reading. I use it mostly for DIY home works & electronics circuit design. It does come with an empty calibration certificate. Doubt there is any relevance to it. The build quality is excellent, feels solid in hand. It is very small in size (18cm x 5.5cm x 2.5cm approx.)

Metravi brand & model DT-725 not engraved anywhere. Just printed on front side. Appears to be a generic product. LCD backlight goes off in 15 sec and makes it difficult to see the measurement range/unit in low light conditions. Probes were good. Temperature measurement is accurate enough. Clamp meter measures DC as well. I could measure charging current of a 7Ah 12 V battery which was just 0.4A. It does have all required features in a small size. Fairly accurate. Calibration certificate is just a blank card without serial number and signature.

Very good product

The display brightness is good, the build quality and its easy to carry , no need to dedicated ammeters.

I took it after not using it for a month or two, suddenly nothing seem to work. I had a doubt about the probes as the temperature function was working fine. I had to check the continuity of the probes with a cheap ₹150 multimeter and later found the issue with the black probe not having continuity. How could this happen in a ₹2.5k plus product? I still remember everything was well and good when I last used it. I stored it well if that is of any concern. Thank god I had spare Fluke test leads lying around which were battered and multiple years used but still works like a charm. Why can't you make such quality at least for the leads? We are putting our life on the line working with electricity and the least you can do is to deliver a quality product. In the end, the quality of the leads was certainly comparable to a ₹150 multimeter leads.

Pros. Very convenient size. Meter build quality is good. Test probes are nice and have sufficient length. Clamp opening is satisfactory. Meter accuracy seems to be good. Feels good in the hand. NCV works perfectly. Cons. Pouch is a little smaller for the meter and test probes together. Pouch is just for carrying. It does not give any protection. A hard case could be better. Temperature probe quality could be better. Back light turns off after 10 seconds. It is really in convenient because backlight does not have a dedicated switch. Flash light is very poor. Not very useful for dark areas. Overall. Good at first impression. Not worth over 3000 rupees.

Working fine.

Using it for solar panel fitting, as in electrical works. Accuracy is very good clamp jaw is good. Compact ca carry in ur pocket for work , it is good purchase and good quality.