Static Cling 5% VLT Automotive Window Tint DIY Easy Install Glare Control Privacy 2ft x 6.5ft (24in x 78in), 5% Super Limo Black (JS242)

Easy to install, looks great

Update: Aug 2020I peel off the film and reuse it on the small windows on the cars. After 3 month is still look just as good as new. You need to use soapy water on both side of the film to apply the film or it will not stick. People who are complaining about the product not sticking is not using soapy water. I try a small piece without soapy water and it just fall off after a few days but with the soapy water is still good after 3 months. Upgrade to 5 star because the product works good and the seam problem was refunded by the manufacturer. The cloudy look is gone when apply to a tinted car window.Spend 20 min preparing the surface than started to install the window tint. Half way in the installation found there was a seam. (Did not know it was a seam until I remove the green tape.) So the cling is 24" X 2 and 24" x 4' 5".During the installation I found the window tint would stretch a bit, not sure what will happen after a few days if the stretch will stay or you end up with a gap. Overall installation is easy if you use soapy water on the surface and the tint first this will allow you to move the tint to your position before you squeegee out the water and bubbles.The tint have cloudy look to it. Overall I will not get a chance to test it because of the seam. I will need to return it.

“5% tint, so you can’t see inside my windows”I watched some YT videos and found a guy recommending this along with his install step by step instructions. Just finished installing (2-3hrs+). Worked out perfect! I give myself a 8/10 on the install. The only hard part is on the inside of the smaller corner windows. I recommend going slow and using some scissors to make small trim cuts so it’ll fit. The weather stripping can be a be tough to get under if you have extra length on the edges. But all in all, it worked. I might redo some of those smaller corner windows later on. But it’ll do for now. I have a Subaru crosstrek and I used 3 rolls of the 5% for all all 4doors, corner windows, the rear window, and had some extra strips and a few squares left over for “red-dos”.ProTip: def do in a shaded area with little to no wind. Use plenty of soapy water and clean windows before applying. If you have a lot of time, you can use a metallic marker to mark out the lines then cut on the floor (over cardboard) so you don’t have to make the cuts while it’s on the window. Just cut cut on the inside of the lines you mark. Go slow and plan it out.Hope this holds up during the hot summer and when I use the windows!*buying the spatula kit def helps!

Blurry, used the suggested application fluid. If you look at the full instructions on there website it says blurriness will go away in about 10 days, been over a month still blurry. Also is blue in colour, would not recommend.

I bought this to cover my rear view mirror at night so that bright light don't blind me. I have a tinted back window so my automatic tinting rearview mirror doesn't really do it's job. So I purchased this to take that glare off and choose the 20% tinted. It did indeed block the glaring lights too well because I had to take it off to distinguish where exactly the vehicles were in order to change lanes. It is a really good product but too dark for what I wanted. I am purchasing the 5% tint which will work great.