2 Pack 10x2.50 Escooter Inner Tube thickened 10" Bike Tube and Repair Kit

Good quality!

These ones have lasted quite a while. The valve sometimes rubs against the metal frame of the scooter so I had to get a smaller flatter cap.

I’ve got these for the Pure Air scooter 🛴. Straight away I noticed that the quality of these inner tubes was better than the one that came with the scooter when starting my repair and compared them, so that was good to know. After a little fiddling I was able to replace the inner. They fit well but I noticed that the air nozzle just touches the frame of the scooter. Which is a shame as I got the correct angle for air nozzle. So I get a slight noise when the air cap and frame touch each other but that will go over time I fingered once the frame or cap wear down. Which it has already started to do. Not perfect but it works.

Use these if you scooter valve comes out of the side as these won't snap on weak point ubwill go through 20 straights before U break 3 angled

These lasted about 3 months then both popped within a week of eachother

It fits and does it’s job. Still using mine today and obviously you have the spare as well. It’s also cheaper than the pure one. However, I did have some difficulty installing it. Also the valve where you pump the tires stick out quite a bit. I can’t put the cap on the valve because it’s literally gets ripped off from scraping against the socket the wheel is connected to. Without the cap it doesn’t scrape on anything. So yeah… it works but it’s not perfect.

Quality is impressive and fits perfectly to Pure air Scooter. I have read some comments about the valve hitting the frame but it is wrong you just need to rotate the inner tube to the other side. The valve should lean to the rim. It will be a bit hard to attach the pump's hose to the valve but just bend it with a screwdriver then you can easily screw the pump's hose.

It's brilliant

I replaced my 10" innertube on my Hover-1, Alpha 1 scooter with this inner tube. It appears to have done the job successfully. I have 2 Hover-1 scooters and they appear to have the same inner tube failure issue. I will also replace the second one too. So far. I'm pleased with the results with the first replacement. It appears to be thicker than the original. It is holding the air. It took a little work to install it, but that is because to the Hover design, not the innertube. Be careful not to puncture the innertube when securing the tire to the rim. Getting the tire over the rim is not an easy task, so be care because you'll have to use some type of small crowbar to get the tire back on.

it's been a couple of months and has been holding out good so far

Good

Fixed my flat tire on my mobility scooter fine. Or rather the bike shop dude changed it for me. And ready for the next flat

Not good , 1 is ok but the other 1 is broken, its like you paying for 1 pcs.😔