GINTOOYUN USB 3.0 20Pin Header Extension Cable FENGQLONG Male to Female Extension Cable

Not much to say other than it works as it should. Build quality seems good.

Pretty good for its price, has a hard time hanging on to the usb header. Also its pretty slow in terms of speed which is below 6MB on average.

I was doing some case-modding with an Optiplex 7010 mid-tower. The USB3 header on that case is a little bit different since it has a little metal latch, which makes it too large for other motherboard USB3 headers. I got this as something that's more "disposable" to basically mush the case header into the extension cable (which will break parts of the plastic around the connector, which was to be expected. I would've been annoyed it it didn't break). After some electrical tape this worked perfectly, no complaints for this extension cable.

Did not work on an Alienware system and did not work on custom pc system. Feels cheap and low quality to begin with, didn’t expect much.

So my USB 3.0 header actually broke on my Asrock B550 Phantom Gaming ITX/ax motherboard. The plastic that surrounds the pins broke on one side, and a few pins were bent. No matter how well I lined up the USB header, it never worked… until I tried this extension cable.With this, I was able to get a functional front USB panel again! I used JB-weld to make sure the header can’t break again, so I can swap cases/motherboard if I so desire.

Connector plastic is weak and poorly sized. Arrived already partly broken but bending the whole cable+extension a little during the installation broke the other side a little, even though it was a struggle to keep it in the connector housing without popping out.