BIGTREETECH TMC2209 V1.3 UART Stepper Motor Driver 2.8A Peak Stepstick Silent Driver for Manta M8P, Octopus V1.1, Octopus Pro, SKR 3, SKR V1.4 Turbo, SKR Pro V1.2 3D Printer Control Board (2 PCS)
Details
- Colorblack gray
- BrandBIGTREETECH
- Voltage28 Volts
- MaterialPCB
- Operating Temperature20 Degrees
Description
🚀 Elevate Your 3D Printing Game with Silent Precision!
- THERMAL EFFICIENCY - Stay cool under pressure with a large thermal pad.
- STEP LOSS PREVENTION - Never miss a step with advanced technology!
- STALL DETECTION SUPPORT - Smart technology that keeps your motors in check.
- VERSATILE COMPATIBILITY - Perfectly pairs with top-tier 3D printer control boards.
- WHISPER QUIET PERFORMANCE - Experience silent operation like never before.
The BIGTREETECH TMC2209 V1.3 is a high-performance stepper motor driver designed for 3D printers, featuring a peak current of 2.8A, ultra-quiet operation, and advanced stall detection. Compatible with popular control boards like Manta M8P and SKR series, it ensures smooth and efficient motor control.
Reviews
S**O
Super quiet, feature packed and a great investment.
Outside of the 5500 series these are the best at what they do, extremely quiet drivers with all the features you’d want making nighttime printing noise a thing of the past.
H**B
TMC2209 Driver: A Quiet Upgrade
Switching to TMC2209 drivers from the older DRV8825s significantly reduced the noise in my projects. These drivers operate so quietly, it's a noticeable improvement for anyone aiming to minimize sound.I installed the TMC2209s on a DRV8825 shield/expansion board that I found on Amazon, and they fit well. There are a couple of extra pins that don't connect to anything, but they're not needed for the driver to work effectively.One thing to keep in mind is the microstepping capability of the TMC2209s, which goes down to 1/8th. This might result in slower movement compared to some other drivers, but the reduction in noise and smooth operation more than compensates for the slight dip in speed.
K**0
They work as expected... configuration research required!
These worked perfectly fine on a BTT Octopus 1.1 for the X/Y steppers.... after a lot of research on configuration. It seems that these use an SPI interface instead of UART. This means that the hardware jumpers must be set to correct positions and also the firmware must be properly configured. This configuration is not well documented, so, happy hunting and good luck!
B**K
Dont work
Unable to set vref or send current to motors, 0/2 working
H**R
Make sure you wire according to the datasheet
If you're working with a microcontroller and not a prebuilt board, be sure your logic voltage and your motor voltage are going to the right pin. The datasheet is correct, I got a module with a poorly labeled pin. Always check the datasheet.
A**E
Great little stepper drivers
The noise difference in StealthChop mode is astonishing. I run mine completely over UART which is very handy. Also the built in step generator (VActual) is great for offloading the stepping logic from your micro controller so it can get on with more important things
A**R
Not all of them work every time
One of these went up in smoke right out the packaging. Besides that, the other ones been holding up great.
L**M
headers came bent and not fully soldered in
headers came bent and not fully soldered in
Common Questions
Trustpilot
2 months ago
4 days ago
