ANYCUBIC 3D Printer Resin 1KG, Standard 405nm UV Fast Curing Photopolymer Resin with High Precision and Low Shrinkage for 8K/14K LCD Resin 3D Printer, Green

This resin works quite well. The color comes out the printer as a very shiney black color. It deepens and gets a little less shiny once cured. I used 6 second exposure time for 0.5mm layers the same as my normal settings and it cures great at that time. I didn't notice it sticking to the FEP film more than other resins and it attached to the bed without any issue. First print went fine and the others have been fine as well.No issues with this resin, will purchase again.

I just got my first resin printer, will be making miniatures and also bigger pieces (Photon Mono X with 250mm Z) so opted for Anycubic's on resin and 1L as a starter, Grey. So setting up the printer took 15 mins to calibrate and get going, i just poured in the resin, pressed print on the test file on the USB and this marvel appeared 4 hours later from liquid resin, a solid fine detail cube approx 42mm square like a cage, then the words in relief crossing each other. The detail is fantastic. Once printed I washed in IPA and then put out in the sun for 20 mins, luckily it shined today, will need to get a UV light I guess. I just have one colour at the moment and leaving it in the vat for now, I will be printing lots more so will see how long this 1L will last, I think it will be ages. Recommended for sure, if you have an Anycubic Resin Printer is sure to work.

I’ve always had trouble with clear resin not being very clear. This resin is the best clear I’ve had so far!Always wanted to print a “crystal skull” and finally I can.. No more yellowing with some careful post treatment..60 second bottom layers4 second exposureNo IPA used and cured in a water bath.Done 👍If you’re looking for clear resin prints, try this stuff! Highly recommend 😁

Good quality resin which gives consistent results, I go through about a bottle of this every week, printing similar items and now I have my settings right I get consistent results. No need to tweak for every bottle like I’ve found with other brands. Saves time, effort and wasted materials.Customer service from anycubic direct is awful, so prefer to purchase on Amazon as gives much better results (arrives faster and better buyer protection)

I've had great success with this stuff. Reading online horror stories I was skeptical and regretted buying black resin. The only fails I've had are due to a damaged Fep. This was my first resin for my first printer and all I can say is I'd buy again but probably wait for a sale. I tend to go with 12 bottom layers and 7.5seconds cure time on 0.025 resolution with consistent success

First of all this resin came in very good packaging with lot of protection to survive all that mad transportation.I got this black resin to print some of parts and I also printed this Batman wich printed very nicely without any problem.Resin is of very good quality and ŕqare giving very nice end results, printed parts are clean and it is easy to clean them from excess resin.Will definitely buy more of this resin.I can recommend buying this product.

I have used a lot of Anycubic resin over the last 2 years, and at first this resin seemed a bit thin. But, its been printing amazingly, with zero print fails to date with the Anycubic mono x. 4 second layer times on 50% power have yielded great results.

Using this product with my very first SLA printer and have been highly impressed with the results.While I found that the resin cost is much higher than the PLA+ I use for my FDM printer its well worth it for the extra detail in smaller prints. Using with Anycubic Photon Zero flawlessly.Can recommend at the price and detail of finished models.