Blazer International C52CW 6-1/4" Round 100W Off-Road Light

Good

I will shop here again.

They seem fairly high quality for $11. I compared them next to KC lights and honestly the glass housing itself looks identical. They both use 100w H3 bulbs.. Theyre both Chromed, and the funny thing is i know these will probably rust over a couple years, in which case ill either buy a new one, or just paint them. Whats funny about that is the KC lights rust as well.. There is a very thick pliable rubber gasket holding the glass housing and reflector on that tightens with a metal band. Little Update: The wiring on it is 18AWG, so if you want to keep fires from happening, i suggest you re-wire these lights to at least 14-16AWG wiring depending on where you put them and the length wire youre using. 16AWG is really only safe up to 8ft with a 8.3 Amp bulb, unless you want a lot of power loss going to the lights. What i did was re-wire to 16GA, but only for 4 ft, and merged two lights into a 12ga WIRE going to a relay and fuse. Also upgraded my alternator to 150A from 94 Amps. But yea deff get rid of the 18GA wires on it. Also after 3-4 days in the humidity the screws holding the straps for the rubber seal are rusting. So i would replace them with some stainless steel scews from the auto parts store. I havent seen any condensation inside the lights yet and its been very humid and rainy in Virginia. Just make sure you tighten the bands very tight. They are a little loose and i imagine some of the reviews of condensation is due to them not being tight. Condensation could get inside the light from the bolt so you could add some silicone to it if you really are concerned about that So the way i saw it, why would i spend $141 on two KC chromed hihlights when i can spend $68 on 6 of these ? If they rust on the outside like i read they do.. Ill just paint em black.. not a big deal. I included pics of them on and off. The dimmer picture is on a rocky road in the woods with just silverstar sylvania headlights and regular 55w fog lights. The 2nd pic is with 4 of these on the roof and 2 on the bumper. Huuuge differe Edit #2. Its been a few months with the 6 lights (4 roof two bumper) and they havent rusted yet besides the screw for the band which i mentioned. The lights are still just as bright as the day i got them. I use them alot on dark roads. We have cross walks where i live that arent lit up and nornal lights dont do it. People have been killed on that crosswalk so i use em all the time in that road. No fogg or any water has gotten in them yet. Dont like the price increase though. Going from 7$ in some reviews to 11 on mine to 14$ in just a few months. Its still cheaper than anything else but yea. Edit #3. Its been 8 months now since i installed these. I still have 0 issues with them. No rust has formed on them outside or inside, except for one. But the rust is only on the pivot ball on the bottom under the light itself. I still havent seen any condensation inside them. I still firmly believe the people who keep writing reviews about this havent tightend down the clamp properly. I live in Virginia, where its raining 50% of the time and humidity here is insaine. The only thing i think im going to change would be to try brighter 130w bulbs and see what happens. Not that im complaining. But im bored and i want to tinker. I still highely recommend these. Especially if you have older Trucks. Also the people writing LEDS are brighter.. Yes and no. Most if not all the led pods on amazon are the same pod sold by 50 different names (chinese) and they all have one thing in common. Th3y advertise 120w and only use something around 10w of power. The reason LEDS in general seem brighter is due to the white light. Our eyes see that better than the yellow when you compare. Brighter or not. I have a 32 year old truck and im not putting a led light bar that belongs on a modern 4door wrangler. It just doesnt look right.

Super bright and good design. All body is chorme.

Sur mon tracteur

These lights are not quite as bright as others that cost much more but I use mine more for cosmetic appeal than need. They look great but they will rust quickly if not cared for. The metal is thinner but for the price I am very happy with them. Also you may need to purchase more wire since you don't get a very long piece with them. Also, since these are 6 inch lights, you can use many brands of light covers (picture) The mounting base is not heavy duty. But holds the lights up.