TAILONZ PNEUMATIC 6mm OD Ball Valve Air Flow Control Valve Push to Connect Fitting BVU-6（Pack of 3）

What a great system and you get plenty of tubing to customize your setup - this is being used as part of an Air assist for a diode laser and has sturdy mounting brackets to the inside of the laser enclosure.

Valves work great as shutoff valves on a aquarium water filter feed system

I bought these to use in my beer lines, and they really work great. They are a perfect fit. Yeah, I know they don't say food grade, but you know what? I don't care!

Goos

Works as described! I used this to cap off an air line in my truck. I removed the passenger seat and put in a cabinet I made so needed to cap air line, couldn’t find an end cap. This shut off works perfect. Not to big to get in the way of anything.

Price right?

third re-edit:after the first two reviews that were misleads based on what I think the "true" quirk is1st: very directional sealing2nd:just doesn't hold pressure reliablynow I believe the true "issue" is that I wasn't using a pneumatic system with slightly atomized compressor oil in the tankthe o-rings inside these valves ONLY work when a small amount of an oil is soaking themwhen I used a hydrocarbon LPG variant through them it leached out the natural rubber oils and damaged one when I passed liquid butane through it during shutoffonce I noticed a benefit from dipping the rubber parts into an oil and giving a light rinse after I tried oiling one that was leaking pure filtered water at a rate well above anything you would "ignore" till you had money to replace the faulty valve it stopped leaking at allI used olive oil cause it was the only non-spraycan oil I had handy and so in a few months a good clean and re-oil will be needed if not before then I urge consumers and the manufacturer to point out the need for oiling the seals occasionally in non-pneumatic (with compressor oil) scenariosthis might be a cause of bad reviews on A LOT of valves for pneumatic use as they tend to use buna-n o-rings that benefit from an atomic level of oil in the gas stream and will suffer pressure sealing issues if a chemical that might wash away oils is usedoil them occasionally and the seals will praise you, neglect them and they will flood your home or fill it with explosive levels of LPG gases or soak your beams till they rot awayhappy DIY part shopping future consumer reading this

Exactly as described,Easy installAnd leak freeHas been in stainless in an automated be environs for airbags and is holding up perfectly!

Válvula básica para sistemas de aire o líquidos a baja presión, totalmente compatible con tuberías de 6 mm. ó ¼, con el cuerpo en plástico que transmite confianza y parece robusto, las salidas con pasador, es una buena opción para instituciones educativas, circuitos de prueba o para pequeñas instalaciones que no tengan que cumplir normativas de seguridad.Se presenta en un blíster sin ningún tipo de información técnica o parámetros de seguridad y en su web solo hay información comercial.La llave gira 360º, muy cómodo para realizar cambios de diseño o pruebas.Las pestañas parecen seguras y agarran bien el tubo.Yo lo he podido probar hasta unos 45 / 50 PSI, funcionamiento correcto.En resumen, un buen producto de marca blanca que permite construir un circuito a un coste asequible…