KAIY Set of 3 Black Metal Guitar Control Knobs for Electric Guitars | Electric Guitar Knobs Replacement, Guitar Potentiometer Tone Knobs Control Dome Knobs for Tele Telecaster Guitar Bass

I had a bass that needed new knobs and these worked perfect! As long as the post is the right size or smaller you can use the Allen set screw to tighten it so they don't fall off. Great replacement. Looks nice too!

They're knobs. They do what they should.

perfectos y de buena calidad

Meh, they're ok. The finish scratches easily, not a big deal. The plastic sleeve insert of which the set screw tightens against requires the set screw to need to be very snug. Snug to point the provided hex key slips. Throw out the provided hex keys and use a better one and you're good to go.

These are nice heavy metal knobs but like someone commented they may need some work to fit. They have a plastic insert which turns out to be a good thing. First, the Allen screw does not go all the way through so it won’t catch the spline. You have to drill a small hole so the Allen will go through and tighten on the spline. Second, they were too small and would not slide down over the spline. Again, I had to drill a bigger hole so it would fit. Since they have a soft plastic insert, it was relatively easy to do with a small cordless drill or you can ream them by hand. If you can do that, they look really good and doesn’t feel like cheap plastic knobs. For the price and looks, I would buy again now knowing what I may have to do. I would start with a small drill bit and gradually bigger until they fit. I’m happy how they came out. Good luck!

Works great.

Received 3. First one was fine. I liked the weight, the finish is nice, and the fact that the middle is plastic isn't a big deal. Second one had an issue with the set screw. The allen wrench interface to the set screw is oversized and soft. As a result, after attempting to gently snug up the set screw with light finger pressure, the opening deformed and flared. Now that screw isn't going to get any tighter or come out, so here's to hoping I don't need to ever change it before I replace that pot. Third one must have been previously installed or poorly manufactured. After attempting to install, it wouldn't go on any deeper than half way down the pot shaft. After removing it, it looked like the plastic insert had been significantly gouged and deformed, preventing it from going down any further. Also, unlike the other two, even after fully removing the set screw, the inner plastic piece would not come free or even rotate. After removing the excess plastic gouging, I attempted to install again. It went down about 3/4 of the way this time but no further. This time, in attempting to remove the knob, it pulled the pot's shaft out with it. Now I'm stuck with a useless knob, a broken pot, and potentially a second one that's in jeopardy if I ever need to remove that knob. Save your money and pass.

They work well.

Was surprised one of the knobs had scratch damage. Otherwise work fine.

Quality is poor, genuine fender knobs can be bought for not a lot more. Grub screws are ineffective