EZ-Access Suitcase Singlefold Portable Ramp with an Applied Slip-Resistant Surface, 4 Foot

The ramps are sturdy and well made. They hold up well in all types of weather with no signs of rust.

I purchased the 4 foot version and found that although it meets the spec for assisting a person in a manual wheelchair for my application, it takes a lot of effort to push an overweight patient up at that angle. That is not a problem with the ramp, which is built very well, it was my mistake. I should have gone with a 6 or 7 foot ramp instead. It makes a big difference. 1" per height to 12 inch per ramp length is ADA spec for unassisted use. The closer to 1:12 rather 2:12 (manual wheelchair with assistance spec) is what you should go for if possible. I ended up returning the ramp and ordering a 7' tri-fold version. These are USA made, very good construction, and look like they would last forever. They are not, however, light weight. I would say the term "light weight" is relative. For an healthcare assistant who is in good shape, it would not be a problem. It may be a little heavy for someone who is older to manage. It can be separated into 2 halves though, which makes it more manageable. The quality of the welds and metal require a certain level of weight, otherwise you get something that is not as safe or that a patient might find alarming. This is a solid ramp. I ordered a 7 foot tri-fold to replace it, which I assume I will need to separate to make manageable weight-wise. Again, there are trade-offs between weight and stability using quality aluminum construction.

This ramp is very solid. I had worried that it would be flimsy, sag, or move around, but there was none of that - the ramp definitely stayed where I put it, and was very stable when I walked on it. The non-slip surface is great. The ramp itself is easy to fold up and move, and I appreciate the handles. The ramp itself is wide enough to fit a walker. The only downside is that the metal ends (both ends) are pretty rough and will scratch whatever they are against. In my case the scratched up some brickwork installed by my grandfather long ago. I wish the ends had some sort of hard rubber covering to protect what they are put against. Ultimately my Mom decided not to use this - she cannot feel her feet and I think was not comfortable with them at an angle, and preferred to continue to struggle with the stairs for now. (I'm keeping it in my garage, though, in case she change her mind later.) Quick note - I struggled a bit trying to decide what length to buy. I eventually found a site which had the following recommendations: For ADA requirements, the ramp should be 1 foot for every 1 inch of elevation. So a 12 inch rise should have a 12 foot ramp. For personal use, it's half that - so to cover 12 inches of elevation you should get a 6 foot ramp.

Easy to install. Safe to transport my husband in wheel chair! Made our Christmas !

This ramp has been a life saver. It is very sturdy, and folds easily. As it is quite sturdy, it does have some left to it; it is not as light as you might think. But that is something I can live with, as the ramp is semi-permanent in the house. The flanges that act as transition from the floor surface to the taboo surface are designed fairly well. But you do have to be sure that you approach the ramp fairly straight-on. Drift in at a slight angle and the front wheels of our manual wheelchair can catch and hinder your ability to get on the ramp. Reverse, and square your approach, and forward to go. Last, the ramp has raised edges that help keep you from drifting off the side as you move up or down the ramp; think of it as a curb. They are very effective and helpful. But the ends of the curbs are cut very squarely and fairly sharply. The square ends could possibly catch a bare foot and would cause some pain if not injury. It would be better if the corners were eased ever so subtly. This gives us more pause when our Toddler is about.