Edge Supply White Oak 3/4 inch X 250 ft Wood Veneer Edgebanding Preglued Roll - Flexible Wood Tape, Easy Application Iron On with Hot Melt Adhesive. Smooth Sanded Finish. Made in USA

This veneer goes on fairly easily with any iron...I used a cheap folding travel iron without issue. There were a few places where I had to go over it a second time and press on it with a flat board, but overall it works well. If your edges are not flat, you'll need to sand down any imperfections. Once cooled, it stays in place well and can be sanded without worrying that it will break loose. Takes stain beautifully and matched the 3/4" oak I used perfectly. Gives a very professional finish.

The glue on this edge banding was very adherent to the plywood edges. There were no flaws or joints in the banding, unlike some other edge banding I have purchased in the past. I will purchase again when needed.

I was hoping to get edge banding that was just peel and adhere, because I had never used edge banding and wanted to avoid the ironing part. The description of this product seemed to suggest it was "peel and stick", but it was not a sure thing, because other places in the product description included reference to ironing it on. I took a chance. It is indeed an iron-on product, and the ironing worked fine once I realized it was not a product I could peel the back off. One review mentioned the importance of putting a lot of pressure on as you iron-- that is true.

The perfect size for finishing 3/4” white oak plywood. Good adhesion and easy to sand down to size. Takes stain and wax finishes just as well as regular oak. Would buy again

Used for a shelf to cover the plywood edge and it came out nicely. Was easy to use. I taped it down before ironing it. Sticks well.

This worked great. I recommend using a new iron dedicated solely for this use so you don't put any other marks on the wood.

If you apply this with a hot iron and a LOT of pressure, just for 10 seconds in any area you are working, it seems to go on very well. Took a few tries to discover a lot of pressure is needed. Happy with this stuff.

Quality of the Edgebanding is good. But the issue is that the strip is just barely wider than 3/4, which means you have very little room to play with when applying to plywood. If you’re careful, then it’s fine. But any little shift, you may find the edgebanding not covering the plywood. It’s not hard to fix (just heat it and shift it) but wish the edgebanding is just slightly wider.