Magigoo – The 3D printing adhesive, MO2016

Tried everything before, like slurry, all sorts of glues. Even Tangit. Nothing works like this product. Holds Abs firm like cement. I havent tested on nylon yet. Nylon is a beast, but also abs. I think it's top notch product

Arrived on time, difficult to remove the film from 3D base plate. Need to be carefull when using it as if more applied cannot remove 3D printed object from the base.

Fantastica! non si stacca piu niente! Non a buon mercato ma dura un sacco quindi ok

Quality is good

Sometimes I just can't get my parts to stay attached to the bed, especially with PETG and ABS. Even with PLA, sometimes it just doesn't happen - especially when the contact area is small. This stuff works a treat, significantly increasing the chance of good first layer adhesion. It lasts for ages because it generally only needs a thin layer to be applied once and one can do lots of prints. Over time it needs reapplying - either straight on top, or wash off previous layer with a damp cloth (water soluble). It won't completely solve ABS/PETG warping issues, but it helps a lot - the bed adhesion can be so strong that the parts themselves break (layer separation) during printing rather than coming off the bed - and that's fixable with a soldering iron. Little tip - first use requires the seal to be broken by pushing the tip down onto a hard surface until it clicks. Also make sure the tip is nicely libricated with the liquid before trying to apply, otherwise you can damage the felt and then scratch your bed.

Magigooは凄い。 よく張り付いて、モデルが歪みません。

Lo utilizo con ABS sobre cama caliente de cristal a 108º y pega super bien. Cero warping con ABS de SUNLU y de FORMFUTURA. Lo malo es que hay que limpiar la cama despues de cada impresión (esponja con agua y trapo humedo), y que suelen quedar restos en las piezas. Si te pasas de producto en la cama te hace un "pegote" en la pieza dejando marcas. Hay que aplicar una capa fina y homogenea, con cuidado de no dejar zonas con excesos.