100FT WiFi

Excelente

Son de buen material le encanto a mis hijos

Funcionan muy bien! Solo para instalarlas batallamos poquito

Lights work very well, nice and vibrant however they do dim out a little bit the more further away from the power source that it gets. Very good stick over all for most of the wall however lights don't stay on all parts of the wall. For the most part overall a really good quality for these lights and a good pricing for them too.

Tal cual como la descripción, funciona bien el Alexa

I brought these light for a birthday gift. Unfortunately I should have open them as soon as as they came. The outside of the box picture looks cheap not as exciting looking as the picture they used to advertise. I have been using this types of lights for more than .5yrs shown many types on my YouTube channel. Has soon as I started to place them some lights started going out. I turned the strip it and it just broke. Like it was dry rotten When I began removing thembit started to tangle. I wish I could get my money back it’s not worth the money

Que es más fácil y seguro gracias por su excelente trabajo

First off, these weren't expensive but then again neither are a lot of the competitors so I guess these were just priced in par with the other led light strips sets. I would like to start as the adhesive is very strong so you must be certain of where you want to stick these. The lights aren't that bright but I bought them for an accent on my kid's bunk beds so they will mostly be on at night. so its ok. The green color is really nice as is the blue but the red is terrible. I know it could be better as I have seen a deep red in the beginning of my installation but now that I am done, the red looks orange and yellow. I checked all my connections and they are tight so I don't know why red is at fault now. If you don't have a lot of connectors in your run I suppose it would be better controlled and you could easily verify if you don't have a tight connection somewhere. I had so many twist and turns and used quite a few right angles and "T" connectors. But please be sure I verified each connection before fastening it completely. I suggest if you do use connectors to not remove the adhesive behind the ends being connected. Contrary to the instructions. With the adhesive backing still on, its a lot easier to slide the end under the terminals of the connector. If you remove the backing you'll have a hard time trying to slide the end under the terminals as the strip is thinner without the backing and its so sticky that it doesn't slide easily under the terminals. So leave the backing on, push it under the terminals and then use scissors to cut the backing for the rest of the strip after the connectors are secure and in place. I didn't realize this until halfway through the project and wish I knew it ahead of time - would have saved me a lot of frustrations. There is a slight hum when the lights are on. Not sure how much a deal it will be with my kids sleeping right there next to it but there is a hum. Probably not an issue if I used these elsewhere like behind a screen or tv but not by a bed...near my head. I wish you were able to cut these strips in smaller sections as I had some difficulty finding the best spot to cut to go around a corner. I wish I had more choices as to where to cut the strip as the dotted cutting lines are spread a little too thinly. So - I would buy these again, I'd buy extra connectors as I believe some were bad or at least some were harder to get a tight and secure connection. The connectors are cheap so buy extras.

Muito bom vale muito

Muito bom