Amazicha 1" Motorcycle LED Tail Brake Light with Bracket, IP67 Waterproof Motorcycle Side Mount License Plate Rear Light Compatible for Harley Sporster Bobber Chopper Yamaha Suzuki Honda Kawasaki

Easy to install, looks great, and appears to be good quality. I'd recommend

Will rate durability after a few rides. Mounted easily in 20 min. Everthing seems like solid metal. Was surprised in the quality and how bright it is. Wired up easily and has a nice window to light up the plate as well. Brake light is definitely bright enough. Great buy for the bobber. Bracket, light and hardware are all solid. Exceeded expectations.

Works good. Easy to wire.

First of all the mounting plate and bracket is built like a Sherman tank. Second, the light itself seems to be made from aluminum or pot metal but isn’t plastic. The wires come with the male portion of banana connectors mounted which was nice but I promptly cut them off to use the connectors I had on hand which exposed the biggest issue I have with this light which is the quality of the wires. The wires are very thin but have lots of insulation which lead you to believe it’s automotive quality 18awg wire. If it bothered me enough I would just solder new wire to the board but it works fine for now but I had to cut the insulation back twice as far and fold the conductor over to get a red connector to crimp on and hold. The other thing is that the license plate light portion gets brighter when you hit the brakes as all the lights come from the same circuit and it’s just the colored lens which changes the color. Other people have isolated the license plate portion of the board but it really doesn’t bother me that much as it’s plenty bright when you crank the brakes and I just want to be seen. The mounting hole is also huge and I believe it’s for the rear axle. My volusia VL800 has another bolt which I opted for to save from removing the rear wheel and I had to make my own huge washer because I didn’t want to run to the depot.

Easy install great look may want to use lock tite on bolts tho

I was surprised that the license plate and bracket was made out of metal. I think around 1/4 or around the area it’s thick enough to not to flap in the wind when riding, i put this on a 95 sportster lefts shock mount it was not bolt on, I had to cut the bracket and drill a new mount hole, also had to grind one of the back of the bolt and nut so it would fit. So if you are looking for a direct bolt It may or may not work and you might have to do some modifications. But other than that so far it’s is holding up. The break light is nice and bright and easy to wire up no issues

Strong metal frame

Housing and hardware all are very solid but after two hours of riding (some rough roads but so what?) FOUR of the tiny soldered wire joints to the circuit board were broken off and the circuit board came unglued, laying in the bottom of the light housing. Tiny, delicate board and wiring will NEVER hold up to being attached to an axil riding on the road. I'll fabricate a new led light setup to use inside this housing. Be ready to do that if you buy it.