DUEBEL Aluminum Alloy Woodworking Hole Opener Slotting Locator Wooden Door Hinge Hole Guide Jig for Door Lock Installation

This did the job admirably. I would say that this wouldn’t be worth it for just one or two doors but I had 7 doors to change so 21 hinges. Took me about 25 minutes to set it up, (used one of the old doors to practice) but from then on it took about two minutes to do the three hinges on each door including the clamping up set up. The little corner chisel device was also a great time saver, easy to line up, one whack with a mallet and the rounded router corners were instantly square. The hinges look perfect. It’s one of those things that I’ll probably never use again but saved me so much hassle and a few hundred quid too if I’d got a carpenter in

I ordered this jig to use with my router to have repeatable mortise joints in the gates I was making. I had read some critical reviews for it, but took a punt. My experience with the fixture is very good, it is well made with the cast body giving good stability to the setup, and the clamps for attaching to wood are very effective. The guide plates are flat and straight and work very well. I took the time to scribe a line on the top of the cast plate to use for alignment with the centre mark on the timber. This is very helpful for overall accuracy of the joints. When setting up you need to take time to ensure the guide plates are square and parallel for the best results. The only improvement I have made is to swap out the m6 bolts that clamp the guide plates and replace them with star knobs, also bought on Amazon. I would recommend this fixture as it is both accurate and good value for money.

This does work fine, although a little fiddly to set up, The best thing is to make a little wooden block that can st against he jaws and show where exactly the edge of the router bit falls. Corner chisel is a nice touch, I wouldn't use it (I just mislay it), but handy I suppose. I don't like that all the screws need a spanner (cheep one provided), thumb screws would be better and I might replace them, alternatively I suppose I could fashion a holder for the spanner because it will just get lost, then I'll get annoyed! One great surprise was that it spaces about 15mm away from the surface being cut, This seems unecessary and limits any deeper cuts. but if you have a number of repetative hinge recesses or handles etc to fit it is a good thing.

Great bit of kit once you set it up for hinges size and lock, it makes your life so much easier.

Its decent all cast aluminium body and guides. But It’s not very easy to use if using firstly and required a lot try cuts to set it perfectly for your needs. Also not very accurate “guides” does have far to much wiggle room in slots. Next thing is nut design for adjusting, it’s real pain in a$$. i ended up replacing original nuts with wing nuts for faster easier adjustment. And needed glue in bolts with some epoxy resin as few of them spin around since I got them

Handy jig too use with a trim router Easy to adjust for cutting out hinges or locks on doors.

found the build quality not that good and hence making accuracy poor

It's good 👍🏼

Makes my job faster and more accurate

outil commode pour faire des mortaises à la défonceuse légère. cependant, pour centrer sur une pièce de bois il faut rajouter un patin supplémentaire (ctp de 18 a 12 mm par exemple ) sur les plots de serrage

Easy and ajustable to use it if you have some millwork skils. I recommend you make some test on a 2x4 or a flat piece of wood before to work on your actual project, but dont count on the measurements scale you have to make the 4 plates adjusted according to your router size plate and the part that you need to attach flush to your door. REMEMBER YOU NEED SOME SKILLS But definitely a must have tool for doors attachments

Très bien

E gusta lo practico y fácil manejó.