BD-R 25GB 16X Blu-ray Recordable Discs with HardCoat, 25 Pack

I've used the Verbatim BD-R 50GB discs frequently for a couple years. They are quite reliable. There is an alternative “Verbatim” 50GB BD-R disc sourced from Japan. It's an all-white, printable disc that you will find on Amazon and other sites. They are temptingly priced at about half the cost of the Verbatim discs you see on this page. I bought a spindle of 100 discs on the bay and many were defective. After translating comments from Asian posters at Amazon, I see others found the same visually obvious problem: white smudges on the outer rim of the discs reflecting lousy quality control. The “verbatim” brand name was evidently licensed by a less assiduous manufacturer in Japan. The manufacturer part numbers for these turkeys: VBR260RP100SV1, VBR260YP50V1 No brand of media is perfectly reliable. From burning discs of various types for 20 years I’ve learned to burn at the slowest available speed. The time investment is worth it because the output has less immediate and long term failures. With Blu-ray, I’ve never seen burning problems with 25 GB, single layer format. The 50 GB, dual layer format fails occasionally even with best quality, Verbatim media. Always use “Verify” mode with your burning software – some errors are not detected during writing, but appear later on reading. I’ve used some of the budget brands of blu-ray media and they worked fine, but I’ve only tried budget brands with single layer 25 GB, and then only a small sample size. The test of a media brand comes with the more problematic dual layer format. It takes a lot of experience to figure out whether an annoying failure rate is coming from hardware, software or media. I expect there are many good software burning packages. I suspected that the burner within my DVDFab suite was a factor in producing errors with 50 GB discs. I tried Cyberlink’s Power2Go burning software and it cut down my coaster rate sharply. Power2Go is the most reliable software I’ve ever used, better even than the venerable ImgBurn freeware standard. I highly recommend Power2Go. I’ve used two quality external blu-ray burning drives, plus a low cost external drive. If you want top reliability with frequent use you must fork-out for the best external drive from ASUS or Buffalo. Any configuration of hardware/software/media has worked acceptably for me with 25 GB discs. For 50 GB I’ve found the Buffalo drive to be slightly more reliable than ASUS. More controlled, extensive testing would be needed to be definitive. edit: I see pioneer has just come out with an internal BD burner. A lot of people swear by that brand. Perhaps there are good internal drive options beyond what I've tested. This concludes my TED talk.

I needed some BD-Rs for PS4 "testing" purposes and these were well rated and cheap enough. I was able to get 3 discs burned just fine, and the discs worked in the PS4. I was interested to see what color they were on the bottom since original CD-Rs were blue, newer ones are light green, and DVD-Rs are a purple blue. It turns out BD-R discs are....dark grey. A bit anticlimactic, I know. I was hoping for a really pretty Blue. Oh well, they were easy to write, worked in what I needed it to, and that's good enough for me.

Great quality. Never had one fail on me and never ended up with a disc that doesn't read properly. Generally Blu-Rays recordables are significantly more reliable than recordable DVDs or CDs. BD-R discs are compatible with the vast majority of standalone players (with the exception of some very early models) and with all game consoles that support Blu-Ray discs. Note that these are single layer discs and are generally not suitable for backing up commercial movies, since they're usually bigger than 25GB and won't fit on a single layer disc without reencoding. Also mind that you need a Blu-Ray writer to burn these. DVD drives will not be able to read or write these discs. Combo drives will also not be able to record these, but will be able to read them once recorded on a compatible drive.

No coasters so far, but I've always had good experiences with Verbatim.

Firstly, Amazon's shipping of these spindles is awful. They will almost always come broken, and I suspect that the damage is passed onto the disks. The 50 packs keep having divots in the disks, but my 10 pack (unbroken spindle) and other disks (cased DVDs) are free of that defect. Please put a note for the warehouse to use a sane amount of packing paper to actually cushion these for shipping. I even did paid shipping for a new set after returning a spindle, and the box was even worse packed, just a flimsy useless bit of brown paper. That said, burned a 24.5 GB movie to a 25 GB disk, only took an hour in my Verbatim 43888 drive, burns at 6x. No errors, plays back fine on Linux. Like the USB connection. Can't wait to keep archiving. Wish the M-Discs were't $10 each even in bulk. These 25GB are less than a dollar each, way cheaper than SSDs nowadays, great for static data like movies etc.

Used makeMKV with 42GB movie and it burned this verbatim bd-r DL disc in 26.5 mins, I saw speeds up to 8.1x using Asus bw-16d1ht inside vantec nexstar DX2 usb3 external enclosure. This is the DX2 not the original DX, replaced the power supply with delta electronics adp-50yh B power adapter for a laptop supplies 12v 4.16amps 50watts , connector is a perfect fit , asus fits great in the enclosure. I saw no bubbling or damage of this verbatim bd-r DL disc after the burn, someone else reviewed that their disc bubbled, that can only be from a burner that has a laser that's too strong. Get the one I use and it should work 100% Tutorial: use makemkv and select backup and check the box for decrypt these files. Use ImgBurn to burn those folders called bdmv, makemkv, certificate. It preserves all menus , subtitles, etc from the original. It will play on a PS5, which is known to not play burned Blu rays. Flash the stock 3.10 firmware with a cross patched firmware called 3.10 MK, makemkv than recognizes that libredrive is available and that microcode is enabled. *update - I bought this external case beginning of April 2023, it's now middle of Sept 2023, so about 5 months, its held up quite nice, I've ripped through 121 DVD's and 70 Blu rays with e burner and this case. The case has held up well. I did have a failure of the Asus bw-16d1ht which died pretty quick, the 2nd Asus bw-16d1ht I got has been holding okay so far however I've had to disconnect it and reconnect it a few times , it appears like it just stops being recognized possibly due to overheating. It could be because the case has not enough air flow and the drive is naturally hot, dunno. I did have to find a guy on the makemkv forum, his guide is called "Ultimate UHD Drives Flashing Guide Updated 2023", and his username is Billycar11, he makes custom flashers to enable libredrive/ microcode. The second Asus bw-16d1ht had a much more recent manufacture date which can explain why it was more reliable but would not allow me to use the 3.10 MK firmware, so Billy had to make me a custom flasher, very strange and cool , it executed using .BAT files which I haven't seen since the early years of windows. cost was like $25 but he used some strange payment app called Zelle. it updated asus to 3.11. if this drive dies he recommended pioneer drives. from reading amazon reviews the internal ones are more reliable, blly also has a list of specific models as well. oh also the delta power supply still works well

I've used 3 Verbatim BD-R 50 Gb Discs before, and my Burning ROM Software gave my 100% good sectors. With this package I bought from Amazon, I had no bad sectors in the first Disc, but got 128 bad sectors in the second Back-up. What I did is that my Software reports the name of the file which was saved on the bad sectors area, so I recorded that file in a DVD, along with a few other files. I recorded a 3rd Back-up and was reported 100% fine. In large Data quantities discs as this ones, is possible to have some bad or damaged sectors on a few discs. Is not supposed to happen too often, but it can happen. That's why I use this software that verifies every sector after burning disc, and reports any errors. You still can use the data, but if you save software on bad sectors, your backed-up software possibly will not work fine. If you save a Word document, you may have a few or more bad data. But I've used Verbatim Discs since 2 years ago, and I've find that they are reliable. As I said, depending on your hardware, and other factors, in a few discs, among several ones, you may find one or two with damaged or bad sectors, but I understand this discs have warranty, so you can check the information on the box, if you got a package with many discs with bad or damaged sectors, if you want to claim the warranty, I understand you can, but if it's only one out of 10 discs, you may not want to lose time, and efforts claiming the warranty for that disc. So, in summary, so far, 2 out of 3 discs have been 100% fine, so I pray when I finished backing-up my documents and data, I'll have no more bad or damaged sectors. I recommend Verbatim Discs very much. I've burned more than 100 25 Gb BD-R Discs, and 6 50 Gb ones, so about 95% have been 100% Good. Just try to use software that verifies your burned discs, and if you want to be sure, and have not verifying software, check your data, you have any other way to verify your data, though 50 Gb is much data to check, so, good luck!

As Described. Still have to burn some data to the discs.

Excelente mídia! Incomparável com as porcarias genéricas, baratas e vagabundas que encontramos por aí. É caro, mas vale cada centavo. Nenhuma mídia deu problema, já gravei dezenas! Apenas comprem! É a melhor do mercado, uma pena não encontrar facilmente em lojas físicas no BOSTIL.

Rien à dire. Une boîte contenant des Blu-ray gravables (1 fois).

Every thing was good

Blu-ray disklerde Verbatim en iyisi sonra da HP

Excellent