Beduan PU Transmission Round Belt 6mm OD High-Performance Urethane Belting Green for Conveyor Bonding Machine Dryer 10Ft

very good product thanku

Welds nice. Hold-up better than the orange belt stuff.

This works well on my drum carder.. it is easy to cut and fuse together. I like that it isn’t smooth and doesn’t slip. Not so rough to hurt the pulleys . I unhook it when I am not using it .. take a picture of it. This is a Patrick green drum carder

I couldn't find the two 20" narrow belts I needed for a 1950s Black & Decker valve grinding machine. I purchased both the 6 & 8 mm belts. Both work, but wish they made this in 7mm. Following the directions, these are very easy to melt together and I tugged pretty hard and couldn't pull them apart. I used a soldering gun with a round flat attachment to heat both ends of the belt at the same time. Quickly, I mated both ends in a V-block which perfectly aligned the joint. Then I used a bench grinder to grind the joint flush. We shall see how long this belt lasts. If you can't find the right size belt for your application, this is a cheap fix. I would purchase again.

This was perfect for my application and fit the rollers like they were made for it. I’m using this for a bicycle roller which is a platform that has three drums spaced apart so your rear (drive) tire is “captured” by two drums spaced apart rollers and another drum that the front wheel rides on. You pedal like you’re riding down the street and use your balance to stay upright. This durable product is easily cut to length by stretching it slightly and cutting with a razor blade. Then you put it around the groove of the rollers and heat the razor blade with a butane torch and push each side against the hot blade and slide them up and hold them together while they fuse together for a stretchy, easy attachment. I particularly like the stretch ability of the product. Not too stiff and not too loose.

This belt is oversized for the pulleys on my 9x20 lathe but let me tell you, I put a 6” 3 jaw chuck on the lathe and it works great! No squealing, I can do all operations including threading. Very easy to splice together, I use a heat gun and it’s strong. I have a more powerful lathe with less money than the original belt. Can’t wait to use it on a tool post grinder.