KBS Coatings 65328 Pure White Xtreme Temperature Coating - 1 Pint, Pure White, 16 Fl Oz (Pack of 1)

In the past I usually used POR-15 products for this kind of stuff but I thought I'd give KBS a try. No regrets. It's a bit less expensive than POR-15 and works just as well. It really improved the appearance of my engine. I painted the exhaust and the intake manifold with this. Easy to apply and looks very good IMO.

This stuff works great. I bought it and painted to paint a turbo exhaust housing on a turbo I was rebuilding. The exhaust temp will run at 1100 degrees with short spikes to 1300. This stuff is holding up great so far. It looks nice as well. I just sprayed it on with a LPHV spray gun and it layed on nice. It dries quick too. Overall, it gets 5 stars from me.

This is worth the money. I used it on a new exaust system before installtion per instructions. Two New Hampshire extra heavy salt and what ever other corrsive chemicals the DOT adds to dissolve cars and there are a few spots of rust, but I can remedy them with Naval Jelly and repaint. Keep trying NH DOT !

I used this product to paint the rusty looking center hub area of my brake rotors. I did not like the requirement that you have to let it sit for eight hours in between coats, but the finished product looks great! So far it’s held up nicely, we will see how it stands up the test of time. For anyone who’s wondering, I just brushed it on. The excess was easily cleaned off the face of the rotors with some brake cleaner and a rag while it was still wet. I did not bake the stuff in the oven like the directions called for. I figured just driving the vehicle would put some heat in the rotors over time. So far so good.

Great product , used it on fireplace

Some of it peeling off the exhaust.

This product performs exactly as it states. I used this product on my hot water baseboards (yes- baseboard heat covers) and it covered all the old rust immediately. Dried incredibly fast and is seriously scuff and chip resistant once dried. Note: You need to work in a well-ventilated area and wear proper protection because the vapors are strong. Read the can it will provide all the safety info. I wish I used this type of product years ago, it would have saved me a lot of time and money. I love the results.

Just as title says GREAT COLOR, Sprays Decent, but is a little bit Pricey, id like to see under $20... Haven't tried on high temperature headers, engine Valve Covers or anything of that nature yet. But plan on it in the future! Will be using the Xtreme 65100 Gray Primer I also Purchased first before spraying on this if I do spray an exhaust manifold/header/Turbo Manifold etc... Im not sure if needed but I also picked up some of VHT Flame Satin Clear and Rust-Oleum 2000° Clear and Rust-Oleum 2000° Primer to try with this... Directions say to bake the primer at 550° for 60 minutes then again for 30 minutes to cure it before painting over it or anything, but the high heat of just running on the vehicle will bake it and cure it in 3 running operating cycles of 1hr drive and 30 minute drive and another 20-30 minute drive. Then can pull off to paint using this Xtreme charcoal paint (you could mask off engine bay and paint them while installed but its impossible to get to the backside of the exhaust manifold (engine side) as the engine itself os typically in the way, so therefore I just recommend to remove the manifold to paint and cure in a baking oven, or just place inside of a grill... If you dont wanna do these necessary steps at least fir the primer~to~paint stage, then i recommend just going with a bronze~gold, or Black Exhaust Wrap to help solve any high engine bay temps etc...

Expensive