DeepleeELEGOO UV 405nm Fast Dry ABS Resin, Standard Photopolymer Resin, 3D Resin, High Precision, Non-Fragile, Non-Toxic, for LCD 3D Printer, Smoke Black, 1000g

I got the White, and there's no streaks or visible separation if it sits in the vat for days. It looks the same. It's kinda thick, so the extra doesn't quickly drain from the hanging build plate. Minor inconvenience if you're in a hurry.It washes off fine in an ultrasonic cleaner using water, with a bit dish detergent and some bartender's friend cleanser. That stuff has oxalic acid which seems to help a lot.Post curing under UV for a long time yellows it a bit...These ABS-like resins are a great improvement. I don't know how they make it, or if the qualities decline over time, but it's easy to print with, it's hard and it's strong. Thin sections are springy. Thick is rock hard. I printed a mold, and then had to break off parts of the mold without destroying the molded (epoxy) part inside (no parting compound required). Forget about cracking it open... It resisted the heat of a soldering iron. It doesn't melt but at some point, perhaps around 600F, an internal bond weakens, bits can be scraped away, and then you might break chunks off of it.Since it resists heat, I made some electrical soldering jigs from it. They hold wires in position while I solder them together. It can withstand a lot of heat. No other filament or resin that I have can do this...

I have bought transparent black, grey, and the white versions of this resin. All three have worked well. But I have had the most success with the white and grey. The white seemed a little more runny than the others, but produced good results. The only things I would advise is to make sure you store it back in the bottle if you don’t use the machine for more than a week, and don’t lay the bottle on its side after you first open it. I was unable to get the bottle to seal well enough for it to no leak if layed down on its side.

This is a cool resin, the ABS property's are good. I understand abs properties mean a more flexible uncured print. But I have a lot of trouble getting my fine detail prints to print properly, the support (I have set to heavy in chituboc with a 70 percent coverage area, effectively major overkill in 90 percent of my other prints) is a pain. The supports do not hold as it is such a viable resin, they are basically rubber and move so much its un reliable adhesion to the print. I have wasted a lot of resin trying to dial this in.

I am updating my review to 4 stars as elegoo has given me a full refund for a bad bottle. That goes a long way to alleviate my issues with this resin.Due to a bad bottle, I spent a week slowly increasing the exposure settings on my elegoo jupiter from 3s to 15s and running town test prints, and I still ran into underexposure delamination. I had to run my settings by all manners of resin support teams to be told that I should avoid this resin if more bottles have this issue. Buy from Sunlu or Siraya if you don't have the time to troubleshoot.

Since I do not have an 8K or higher resolution printer I will be using this until I do.Then I will switch to the Mk II version.Until then I will continue to get this on a two month schedule.