USB to DMX512 3PIN XLR Interface Adapter/dongle Computer PC Stage Light Controller Dimmer USB to DMX RS485 Serial Converter Cable (Length:16ft)

Great Dmx Interface, using 2012 macpro/10.14.6. No issues working with Lightkey (you don't need to install drivers), however, will not work with Enttec Emu software. I do believe the Enttec software has chipset recognition only allowing (very expensive) certain interfaces to be recognized. I experienced no latency with this interface, no crashing or freezing. Update in the future if I have any problems. So far, so good!

This item does not come with a CD so there are no drivers or description where to get them from

I have just run a show using this adaptor and I have no complaints. I only ran a couple of channels using this adaptor, but it worked perfectly. I used it on a Ubuntu Linux platform using QLC+. No drivers required, just plugged it in and it worked perfectly. Good value and no issues so far.

The USB connection was so poor there was over an inch of side to side movement when plugged into the laptop. Needless to say the connection was very poor and the item could not be recognised with the recommended software. Item returned for refund.

Doesn't work with freestyler and no cd or instructions included as promised.

This interface supports Open DMX software on my Mac with no driver, so Lightkey, MagicQ and others. Half the price or less than the Enttec Open DMX USB but works the same. Only difference is the 3 pin out put rather than 5 pin - actually an advantage for me, means no adaptor required! So, for those of you looking for a keenly priced Open DMX Interface for your computer, look no further!

Ottimo rapporto qualità prezzo. Funziona con tutti i software che accettano un convertitore universale. Mai avuto problemi.

ca ne fonctionne pas ...

Pretty straightforward USB to DMX adapter. I occasionally work with DMX lights with some community theatre groups and ended up needing some computer control lights for a small project at work. I did some of the setup and initial testing on a 2019 Macbook Pro and macOS 12.6 before moving it over to an off-brand PC and Windows 10. No real issues with either just make sure you have FTDI D2xx drivers installed. I already had those on my Mac since I work with Arduino and other MCUs that use FDTI USB to Serial interfaces but had to get the driver for the windows computer. Once that was taken care of took almost no effort to get it and the light fixtures I was using running with QLC+

Macht was es soll und das gut nur eine online Anleitung mit Treibern wäre hilfreich sollte man wie ich seine mitgelieferte nicht mehr finden

Non funziona