ORX PLUS TOOLS PO-045-TORXPLUS Tools Deburring External Chamfer Tool, Tungsten Blade, Deburring Drill Bit, Remove Burr Tools for Fit 1/8 inch-3/4 inch(3mm-19mm)

Stop hours of filing.Works well....

Bought for hubby for use on his motorbike. He had been looking for it for awhile.

The blades chipped on first use. I used it on threaded rod 8.8 and amazon refunded me

I had to cut down the studs on my rear axle as the ARP ones were too long to use with closed lugs nuts. The was able to go through all ten studs and chamfer down the sawed off end on all ten studs. I used a regular cordless drill set to the lower speed setting (1 instead of 2 for my older Dewalt) and the tool worked its magic on the ends.I'm not sure how many more studs it would have in it, but I know that it went through ten hardened studs with great results and still has material left in it for more work down the road. It's in my drill bit drawer now for use on the next round of all-thread, studs, or bolts I need to chop down and chamfer.The pictures show the first stud and the last stud I used this on as well as what the starting point was for each stud.

Works well thanks

Thanks!

Just used it to debur 4 long bolts I had to cut down on my trailer. It worked flawlessly.

I've never used one of these deburrers before, but this particular one showed no visible wear after deburring/chamfering both ends of 8 lengths of Ø6mm stainless steel round bar. I followed the recommendations for speed, used cutting lubricant, and held the bars firmly in an engineers' vise. There is only one contradiction I noticed. The tool works best if the end of a round bar is free of burrs! Start off slow and be prepared to stop and start again if your drill jumps around a bit. I imagine the deburrer would work best if both the bar and tool were mounted in chucks on a lathe, but if I had a lathe, this tool would be unnecessary.