KregPrecision Miter Gauge System

Arrived promptly but with 2 minor bits missing. New parts arrived in a couple of days following a phone call. Very accurate. It has taken my use of the saw bench up a level in accuracy.

Nice and excellent quality gauge for the table saw helping to make exact accurate angles cuts! The only down side is the assembly instructions are not very clear making assembly a little complicated

j'acheté cette jauge pour ma scie sur table évolution rage 5, satisfait de cet achat,après une modification de la barre alu guide qui a une épaisseur de 9,5mm à 7mm car la profondeur de la rainure de table n'a que 7mm,je pouvais le fraiser au boulot.la largeur de ce guide est de 18,6 et la largeur de la rainure de table est de 19,6,dans la largeur de ce guide y'a 5 taraudages M5,des vis M5 sans tête sont avec pour règler le jeu,autre bémol le mètre ruban adhésif est en inch,j'en ais acheté un métrique sur amazone

la verdad es que no he podido utilizar el sistema de precisión que adquirí, me ha faltado tiempo, sin embargo revise la pieza y tiene un acabado excelente y un ajuste de piezas también excelente no presenta holguras, no tengo la menor duda que en cuanto lo pueda utilizar funcionara a la perfección.

Recht teuer aber definitiv sehr gut, sehr präzise für holzarbeiten

I do segmented turning and also make some small boxes that generally are unusual in shape (trapezoidal, triangular, rhomboid, etc). I need to be able to do repeatable angles and sometimes do staved boxes that require longer rips than I can do on my Kapex miter saw.I own a Grizzly G0700 sliding table saw, which is a right-tilting table saw and with a non-standard T-slot so I had to make do with the OEM miter gauge, which means constant trial and error and a high scrap rate.Recently though, I added a 10" cabinet saw to my shop and did the usual, OCD thing of reading a zillion reviews of miter gauges and narrowed it down to the Kreg and of course, the Incra (having tried the Osborne and didn't care for it).I chose this because I like the ease of use, the flip stop and the easy to read gauge for dialing in precise angles. I also like Kreg products in general, so was a bit biased in their favor as the owner of a few of their other jigs.So I've been pleased overall with no negatives really save for two, which I'll get to later.Assembly is simple, straightforward and quick. Read the directions but still, dead easy. It took only a few minutes.They claim the gauge is dialed in at the factory and that is true as far as I can tell. Mine was. It's also very sturdy with none of the deflection that I was concerned might be an issue based on some other reviews. But I will admit that I don't make long cuts very often.Build quality overall is really nice and the fit and finish is the usual Kreg, that is to say, nice. However, I find that the plastic bushing between the flip stop and the end piece leaves something to be desired and leaves a bit of play that I don't like. You don't really have to account for it in your measurements, but I just don't like it on principle.The other knock is the nylon screws used to tighten the bar so it runs in the T-slot without play. The screws SHOULD come pre-installed and I'd like to see them made of a more durable material; perhaps a hard material with a nylon head or even kevlar or something. I have little confidence that these will last over time.Having said that, this is an excellent miter gauge that will last a long time. It is heavy, well-machined, precise, easy to read, easy to use and solid. I'd buy it again