BIRCHTREE Metal Garden Shed Pent Roof 3X5FT Small Outdoor Storage Cabinet Hinge Door Grey

The instructions were comprehensive and easy to follow. The components were well protected and machined. I managed to put 99% it together on my own with a small amount of assistance from my 11 year old son. So lang as you’re assembling it on a flat/level surface, all the holes line up fairly well. The only drawback is that it will take you longer to peel the plastic protection off every panel than it will to actually put the shed together. Honestly it’s great value for money in my opinion.

Great shed. Definitely need 2 people to put together. Has weathered well, no leaks. Great size I have 3 bikes, 3 scooters and shelves in mine.

If you only read the first line: Don’t buy this. I’m a confident DIYer with 50 years of experience (starting with House of Holland and MFI furniture for those with long memories). I’ve assembled hundreds of items, but this shed was by far the worst assembly experience of my life. It’s a cheap shed, which I expected. What I didn't expect was the "protective" plastic film bonded to virtually every one of the 40+ parts. The Plastic Problem: This isn't just a loose wrap. It is thin, cheap film heat-bonded to the metal. Each large sheet took over 40 minutes to clear. I stopped counting at 25 HOURS of peeling. My hands and fingers literally seized up; I eventually had to pay my children to finish it just so I could start the build. Why you can't ignore it: Some reviewers don't mention it—likely because it's so well-bonded they don't realise it's there. But if you leave it, the sun and rain will turn it into a peeling, shredded mess. The Build: The assembly itself is actually straightforward (4-5 hours). Holes line up if you stay square, though the plastic washers are flimsy and I doubt they’ll stay watertight in a storm. The Base: Be aware you need two bases—one to sit the shed on, and a floor inside to cover the raised framework, which is a major trip hazard. I had to notch OSB board around the door frame to make it work. Summary: If you value your time and the use of your hands, look elsewhere. The "savings" on this shed are paid for in 25 hours of agonising manual labour. My hands are still cramping up two days later. You think you're buying a weekend project, but you're actually buying a part-time job in a plastic-peeling factory.

Great storage shed for money. A few Dents and holes that didnt line up.Quite flimsy during assembly but fine when finished. Needs 2 people at certain points .

Good quality product. Storage capacity is good Plenty of screws for the project Instructions a little confusing Assembly is a little more finicky than expected. 2 stabilising bars missing for the door.

You will need plenty of patience as this is very flimsy in construction [hence needing 2 people to avoid damage] and quite difficult to erect if on your own. Read the instructions carefully before starting, check that all the parts are there and don't build it on a windy day! It is best erected on a level surface such as a lawn where you have access on all sides. It’s very lightweight so can be manhandled a foot or so [slowly] into position by two people if you need extra room as it is assembled from the outside. Instruction booklet says 2-3 hours [advert does say a day], took 1 hour to sort the supplied base, 8 hours to build sides, 4 hours [day 2] to put on roof and doors. Then you need to fit an internal floor [not supplied] which is about 42” x 7’. Height at rear is 5’2” and 5’10” at front. Overall a lot smaller than advertised [lose a *]. You will need a cross head screwdriver, an electric drill and a spanner to tighten the nuts and bolts. It comes in two boxes but this means the overall design needs more refinement as some sections are very small and the base is made of small sections which makes it fiddly. I had no difficulty with the holes lining up on the walls, but the roof was another matter. If a part looks as though it will not fit, don't force it, stop, go and have a tea and come back to it. The instructions are poorly translated into English and the diagrams are not always clear. [lose another *]. But the door runners are terrible as they are hooked into a C channel rather than resting in a gutter [as on most greenhouses] and the doors are not very sturdy, [lose another *] but works better as a storage unit rather than a shed. In general, metal sheds are more fiddly to make, there are sharp edges but careful handling should avoid cuts, the main danger was in separating the panels from one another as they had become wedged together in the cartons. At the end of the build you might walk away with some plasters on your fingers but definitely expect some scratches! Having said that, it was one of the cheapest units around [gain a *] and two not very technical people did manage to erect it -eventually, does what it was purchased for and is quite sturdy once completed, but direct knocks will easily damage the sides. UPDATE 4/5/15 Just ordered some rubber sheeting as the roof leaks like a sieve from the screw holes! [something I half expected, even with the plastic washers supplied].

does the job, my gear has survived the winter and remained dry.........was easy enough to build though needed 2 of us....was a bit fiddly in places, but i rate my DIY skills at 2/10 and I managed it with the aid of my wife holding some sides up while i screwed it together....only 1 screw didn't match the pre drilled holes.... would buy again...

Really good, I enjoyed building this shed, very easy to follow instructions, looks good and just the right size for what I required.