SuPoo for Mazda Black Sporty Metal Evil 'M' Rear Trunk Badge Decal Emblem Glossy 3 5 6

Despite the 4 out of 5 stars overall and reviews, I give this a 5. Very happy with what I received. Had to manually bend at the center axis, very lightly, and also the horns that face the ground. VERY LIGHTLY. Just enough to make the curve. This is made from steel not aluminum. Take your time. Absolutely worth 10 bucks. The two faced tape was die cut very well, I would give the tape a 4 out of 5. Heat it up a little with a hair dryer.

Doesn't flex much so you might need to work around that a bit and plan ahead.

Go buy 3m tape, don't use the stuff it comes with. You'll loose your emblem in about ten miles. Powder coated is good, we stripped ours and did them a different color. Held up to the oven and the acid. Quick little mod to stand out in the car scene just a little. It's subtle change, but people always ask me where did i get them....

Very straight forward installation. Have to pretty meticulous since this badge does not have the inserts to go into the holes into the hatch. Preparation is key, but for 8 bucks you can’t beat it—if it falls off just buy another one.

I have an 04 rx8 the badge looks nice but it had no curve to it at all so the bottom corners stick out a bit. Anyone who is familure with the rx8 knows the trunk barely has a curve to it, the badge is slightly bigger than the stock one on the good and trunk. The main downfall though is the 3m tape that comes with it is slightly bigger and sticks out of the sides. I did my best to trim it down a bit before installing but it is still slightly visible. If the badge holds up only time will tell my main concern will be carwashes. With that being said it overall it does look nice and it isn't to expensive, it is metal as the description stated, which could be a bad thing because it adds more weight, and may cause it to fall off. Make sure you're prepared to remove the glue from your stock badge will take about an hour if you do it right I used break cleaner and a flat yellow platic thing I found at orillys, along with paper towles. I was planning on buying one for the front too, not sure if I will or not now. I'm going to wait and see how this one holds up for a bit before I decide

The rear door is rounded, this emblem is flat. When you put it on, the edges on both sides don't sit flush and aren't attached to the car. Not only does it look stupid, it won't stay on like that. This product wasn't designed to fit the shape of the car. It was left flat because it's cheap to make it that way. But what's the point of thing being made at all if it isn't going to work? Probably because it's so cheap most people won't bother returning it. Then your left with the adhesive that is almost impossible to get off the car.

Nice emblem worked as it should and easy to install. Fit well on the hatch.

Well made product not plastic. Did not use the double sided tape came with used adhesive promoter and 3m tape. Do have to work it out to shape of placement. Satisfied with purchase

لم يصلني المنتج ؟

J’ai commandé pour un mazda Cx5 2017, ca ne fit pas sur le coffre arrière. Super produit par contre mais plus pour mazda 3

Adhesive is sub par. Product is flat, if you have a curved surface you may have to do some finagling.

The material of the badge was amazing the adhesive was amazing stuck right on. Very good product for the money spent would recommend!

I had to bend it to fit on my 2021 3 hatchback. This one is bigger than the OEM badge. It came with a chip in the paint for goodness sake. I really only bought it to cover the holes in the trunk after removing the original logo. I recommend plasti dipping the original Mazda logo rather than buying another one