25 Values 1/2W Resistor Kit from 1 Ohm to 1M Ohm 1/2 Watt 1% Metal Film Resistors Assortment

Good pack for building up bench stock of lots of different values. Been using them to breadboard DIY guitar pedals. The leads are really really thin, not as thick as the other pack of resistors I got in a different kit. But it will be fine when I start soldering. They are a little thin for breadboarding.

This small compact box contains just about any value of 1% 1/4W resistor you are likely to need. Ten resistors of each value are fixed on a section of a strip of reel tape with the specific value printed on. This makes for a much more compact way of storing your resistors compared to the old sectioned pull out drawers which take up space and have a tendency to tip over and spill out everything. The selection is good for finding which values you are going to use the most so later you can order of just those values that you need the most.

Very handy to have for the occasional repair or DIY project. So far they all have worked well.

so far so good, hard to read what values unless you know the color code,, it is printed but hard to read,

These are really big (got the 5 watts) and packaged nicely. Some of the bags (more than 1) had long black hair strands in them. Kind of gross, but at least we know it was packaged by a worker--and not a robot. Also the word "each" is misspelled on the label. Totally worth the money, especially to stock up on a sort of rare wattage that I don't find too often while scavenging old electronics.

Just what I needed at a great price delivered.

Not the sellers fault, but you should know these resistors are very small! The lead wires are so fine that they are difficult to push into the prototyping boards I use. Sometimes they don't make great contact. I wish I had bought the 1/4 watt ones.You can forget reading the color codes... they're microscopic.Also, after thinking about it, I wish they had fewer values below 10 ohms and over 1 megaohm. That way, they could give more useful 10 ohm to 100kohm values.

I received two 10 piece taped portions of 68 ohm resistors in the set. Their mistake. So. I thought I'd test them. They were all in the 61.xx region, approx. 10 % off. I had already tested the 100K ohm taped set of 10. They were all less than 5% off, approx. 3%. So, there's obviously poor QC.