Ikpek 4pcs Joysticks Replacement for DualSense PS5 Controller, 3D Analog Sensor Wheel Thumb Sticks Joystick Rocker Module Replacement for Playstation 5 Controller

As you all may not know you need the correct toggle blocks with 2K3 Ohm Potentiometer in them which here our American friends have, these are specifically for PS5 controllers only and do the job fantastically. Its well packages as its coming a long way so will also take a couple of weeks to get to the UK but I'm very happy with them as 2 block replacements went like a dream, 2 useless £65 controllers working perfectly again and yes i just changed the left analogue sticks on both as I'd tested them online, rights were as usual fine. I have quite a few more to do now as everyone is fetching theirs to me so will be ordering more.

I took the guts out of part of this and it fixed the stick drift in my PS5 controller. I later got drift on one of my XSX controllers as well and swapped out the guts with this and it fixed it just the same. Both Sony and Microsoft seem to be using the same internal parts. Completely worth it to fix both of my controllers and I still have several guts left to fix 6 or so more controllers if I need to.

I replaced both my joysticks in my controller. I went online to calibrate them for center and circularity and they calibrated fine. Which the circularity actual came out better than the new controller I bought. But after moving the sticks around a bit and pushing down on them, the left one would just jump off to the right. I pushed/moved the stick around a bit and it would go back to center. So I replaced the joy stick again and all test where fine. Well, until about a few hours of game play and the left stick would just start going the the right again. Testing online again, I could see the left line jump off the the right just for a bit and come back to center. I could not get it to stay there, at the right like the 1st joystick. So I just gave up on this controller and bought a new one. The board installed was a BDM-030.

dure 3 horas en colocar el remplazo y la pieza estaba danada no era grave pero me ubiera gustado que el mando quedara sin siquiera un poco de drift en fin la pereza me gano y subi la zona muerta un poco en lugar de remplazarla de nuevo. mi recomendacion es hacerlo con los materiales adecuados y no esperar que funcione a la primera. suerte a los que los haran por su cuenta...

Fixed my controller .