Rubber Edge Trim Guard 10ft/3m, Adhesive Free Door Edge Protector, U Shape Edge Seal Strip with Embedded Metal Clips Fits 3/64" to 1/4" Thick Edges (Black)

Used this edge trim on an outdoor planter to cover some sharp metal edges, and it worked great. It was easy to install, stayed securely in place without adhesive, and provided a clean, finished look. The material feels durable and adds a nice layer of protection. Exactly what I needed and would definitely buy again.

Appears to be good quality, easy to install on a few sharp edges on my jon boat project. I sliced my finger up cutting these with tin snips so wear gloves or handle with caution. Good value in my opinion, gives a finished look.

This worked just perfectly to cover the raw edges of the 1/4" plywood that our travel trailer's bed rests on. Simple to apply, and it looks clean. No more snagging my clothes, sheets, or skin. I was able to cover the edges of half a rv queen size plywood platform with one pack. Ours is hinged about halfway, and this made it from one side of the hinge, around the foot to the other side of the hinge. Had about 10 inches extra, that was easily trimmed with kitchen scissors.

Item was okay but a lot smaller than expected. It wasn’t suitable for our needs but the product was fine.

I purchased this to wrap the metal perimeter of my Sprinter van windows. I wasn’t sure it would work but decided to try it. I’m so excited to report that it fit perfectly and I was able to cover the sliding door window and both back door windows! Highly recommend as a much cheaper alternative to purchasing through MB!

I needed some rubber grommets for holes I cut in a galvanized metal tank. This worked great. I also used it to wrap a galvanized metal wire so the wire would not cut into cords that are draped in over it.

Fit perfect, great value

I used this to repair the leading edge of my 13-year-old car's headliner. The fragile fabric had come detached from the foam board backing where I have emergency lights and cabling run behind the headliner. Looking into the vehicle from the outside through the front window, the ripped fabric and exposed foam looked bad.I manually spread the rubber trim apart then pushed it firmly over the edge of the headliner and loose fabric. Starting on the left side of the window and working my way right a few inches at a time, I squeezed the little clips embedded in the strip tightly closed. I used sheet metal cutters to trim the strip to the exact length.Pros: Easy installation, looks good and covered defect, no adhesive required so easy to adjust, inexpensive.Cons: A somewhat strong rubbery smell which hopefully will dissipate over time.

Great Product. Easy to use and has stayed in place with no Issues.

Flexible, strong. Good metal clips within. Fairly grippie exterior

Fits well hold well, great

It was purchased to trim our plastic windshield in our sxs it works amazing to me it is way better than what came with it since you can put it on in one piece because what came with it was in pieces and they worked loose and I lost them. This doesn't happen with this edge trim I highly recommend it

Worked great for my truck cap!