FEP Film 2pcs for Photon Mono 2/Photon Mono 4, Integrated Design, Easy to Replace

Better than the last ones I bought. These have lasted through a bunch of prints with no issues and they haven't gotten loose. I haven't noticed any effect on print quality either

Product is exactly as described, has good quality and just what I needed! It was delivered fast too which I appreciate a lot

worked wonderfully, way more durable than the official anycubic stuff

Works great

Solid and sturdy. If applied correctly and used with care, you can get 2 or 3 life cycles out of one. When the Photon Mono 2 States to change the film. Just hit the reset menu. You'll know when it's time to replace when you start getting an unusually high amount of failed or defective prints or the film is cloudy even after cleaning it. If you have not had a lot of failed prints to scrape off, the film will last though a couple of messages before it actually needs to be changed. That's dependent on your usage, however, and not any guarantee. Keep the tank and the film clean and you'll get longer usage. You can't re-use or change the film from the holder. They are tossed when the film is done and you have to use a whole new assembly. DO NOT try to re-use the film holder with separate film. It will leak and you will destroy your printer trying to save a few dollars. Don't do it !!!

Great product. It works exactly as expected with no issues so far. Installation was easy and straightforward. I use it with my Anycubic Photon Mono 4, and I haven’t had any problems at all. Prints come out great. Would definitely buy again.

Actually you should change the FEP more often, especially after you had a disaster like parts of the print did not lift off the FEP. Absolutely NEVER touch the FEB with anything. Even wiping it with a tissue will leave scratches you will see on the print. Always "clean" the FEP by exposing the entire area for 30 second, the lift the exposed (hard) resing using a soft plastic spatula from the edge, because even a plastic spatula will leave a nasty mark. At the edge it does not matter so much

Es tal cual como las pedí y excelente calidad, todo llego muy rapido

Magnífico, se ajystó perfectamente a la impresora 3D y reemplace el original…. No sabía que se tenía que hacer esto y de pronto prendió el aviso, afortunadamente ya tenía el reemplazo….

Totalmente compatibles con photon mono 4/4 ULTRA, no son ACF por lo tanto se deben cambiar los parámetros de velocidad si es que usas la version 4 ULTRA.