Joinfworld Outdoor Electrical Box Waterproof IP67 6X6 Plastic Project Box Enclosure Weatherproof for WiFi Electronics Solar Network Marine Outside with Stainless Steel Hinged

Well built. Nice quality. Worked perfectly for an outdoor mounted thermostat!

Excellent quality. This is the perfect product for our outdoor installations where we need to mount expensive electronics.

This is the perfect size box to house the transformers for our sprinkler controller and x-10 remote unit. Not only will this tidy-up the connections, the weatherproof aspect will mean fewer spiderwebs to take down. The metal locks/clasps make opening and locking simple and are attractive to look at.

We found this box to be high quality and perfect for our needs to house the transformer for our video doorbell. It comes with everything you'll need to surface mount it as well as weatherproof cable connectors if you need to use it outside. It's a wonderful surprise to find this kind of quality at a reasonable price. We're glad to recommend this to others.

Well constructed project box is water proof with sturdy plastic parts and metallic clasps. Had a little difficulty getting the box open initially, as the rubber gasket stuck so well, it was holding the door shut... but a little prying with a butter knife popped it open. I was very pleased and might buy another one for another project.

If you have an indoor/outdoor transition to make and protect, this box fits the bill for sure. Easy to setup up a board or interface on the internal grid. Seals tight against all the elements.

Perfect size selection, good quality latches and more connection parts than I needed but that's OK 😊.

I use it for meshtastic node. Works great. Holds the node, a 6v battery, amp and room for connecting solar. All dry.

I put a Micro-Air Flex soft start for the AC into it. An easy install with the grid board. The glands made a nice tight seal. I'd buy this product again.

Great

Me llego muy rápido y en buenas condiciones. Incluye lo de la fotografía y es bastante amplia, un material de buena calidad.

Good product and price. Water tight. Mounting plate makes for easy install of components with #8 screws

I intalled my Starlink Gen 3 on an outbuilding on my property and I used this enclosure for the router. The three knockouts on the bottom are perfect: one for power, one for the cat6 cable to the antenna and the third for the cat6 cable run back to the house. If you do this, buy the ethernet jack pigtails also available here on Amazon. The box is a bit tight for the router and the power supply but once you finagle them inside use some double sided tape to hold them in place. I use this in an unheated application and it works fine even in the winter. The cost of the enclosure is a good value and the box and clasps are good quality.