Width: 30cm Length: 5M 1.5 mil thickness of dry film can be completely cover a hole of 0.25 inches The dry film can be used in the most ordinary plating solution, no wrinkle, no discoloration Operating steps: grinding CCL,using the finest polished clean water frosted paper on the line. removing film, photographic film is sandwiched between two layers of film, the first side can make use of transparent tape tear torn, try a few on the line. and then foil, copper clad laminates can look a little cleaner, pasted, try not to have bubbles. good paste membrane used presses, not too hot, about 100 degrees from the fixing. the printed circuit board film, suggestion is to use film, the fine could reach the highest degree of accuracy if you did not ask for the paper to print it with sulfuric acid trip. the printed circuit on the photographic plate (Note: Dry film is negative, so to highlight the print, which we usually use photographic plate opposite) with ordinary energy-saving lamps 10 or so, if there is exposure Machine 1 minutes on the line, the sun not tried, it should be 30 seconds -60 seconds, the exposure process Obviously, since the photosensitive film will change color when exposed to light, the light becomes dark blue. You will easily see your circuit diagram appeared on the board. Package included: 1 x 30cm Photosensitive Dry Film
Trustpilot
3 weeks ago
4 days ago
